Page 76 / 94
Scroll up to view Page 71 - 75
71
Figure 3: Smart card or certificate properties
4. Windows 2000 RADIUS server Authentication testing:
4.1DUT authenticate PC1 using certificate. (PC2 follows the same test procedures.)
1. Download and install the certificate on PC1. (Fig 4)
2. PC1 choose the SSID of DUT as the Access Point.
3. Set authentication type of wireless client and RADIUS server both to
EAP_TLS.
4. Disable the wireless connection and enable again.
5. The DUT will send the user's certificate to the RADIUS server, and then
send the message of authentication result to PC1. (Fig 5)
6. Windows XP will prompt that the authentication process is success or fail
and end the authentication procedure. ( Fig 6)
7. Terminate the test steps when PC1 get dynamic IP and PING remote host
successfully.
Downloaded from
www.Manualslib.com
manuals search engine
Page 77 / 94
72
Figure 4: Certificate information on PC1
Figure 5: Authenticating
Downloaded from
www.Manualslib.com
manuals search engine
Page 78 / 94
73
Figure 6: Authentication success
4.2
DUT authenticate PC2 using PEAP-TLS.
1. PC2 choose the SSID of DUT as the Access Point.
2. Set authentication type of wireless client and RADIUS server both to
PEAP_TLS.
3. Disable the wireless connection and enable again.
4.The DUT will send the user's certificate to the RADIUS server, and then
send the message of authentication result to PC2.
5. Windows XP will prompt that the authentication process is success or fail
and end the authentication procedure.
6. Terminate the test steps when PC2 get dynamic IP and PING remote host
successfully.
Support Type:
The router supports the types of
802.1x Authentication:
PEAP-CHAPv2 and PEAP-TLS.
Note.
1.PC1 is on Windows XP platform without Service Pack 1.
2.PC2 is on Windows XP platform with Service Pack 1a.
3.PEAP is supported on Windows XP with Service Pack 1 only.
4.Windows XP with Service Pack 1 allows 802.1x authentication only when data encryption function is
enable.
Downloaded from
www.Manualslib.com
manuals search engine
Page 79 / 94
74
A
A
p
p
p
p
e
e
n
n
d
d
i
i
x
x
C
C
W
W
P
P
A
A
-
-
P
P
S
S
K
K
a
a
n
n
d
d
W
W
P
P
A
A
Wireless Router: LAN IP: 192.168.123.254
WAN IP: 192.168.122.216
Radius Server: 192.168.122.1
UserA : XP Wireless Card:Ti-11g
Tool: Odyssey Client Manager
Refer to:
www.funk.com
Download:
Downloaded from
www.Manualslib.com
manuals search engine
Page 80 / 94
75
Or Another Configuration:
WPA-PSK
In fact, it is not necessary for this function to authenticate by Radius Server, the client and
wireless Router authenticate by themselves.
Method1:
1. Go to the Web manager of Wireless Router to configure, like below:
2. Go to Odyssey Client Manager, first choose
“
Network
”
Before doing that, you should verify if the software can show the wireless card.
Open
“
Adapters
”
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live