Page 16 / 76
Scroll up to view Page 11 - 15
MWN-WAPR150N Wireless Router
5.
“Bridged Mode” might be called “Transparent Bridge
Mode”, or “1483 Transparent Bridged Mode”.
6.
Once the modem is set to Bridged, it will reboot. At
this point your computer will no longer have access
to the internet.
7.
Connect the router between the modem and the
computer using network cables.
8.
Access the Router’s GUI (See Chapter 3.2 Login to
the Router)
9.
Click Next on the Setup Wizard.
10.
Select “ADSL Virtual Dial-up via PPPoE” and click
Next.
11.
When prompted, enter your DSL username and
password, click Next.
12.
Restart the computer (See Chapter 3.2 – Step 4 to
Configure your Wireless Network)
2.1b No Modem Access
1.
Open your internet browser and in the address bar
type the IP address of the router (default is
192.168.0.1). Enter the username and password
(‘admin’ for both) when prompted and click “ok”.
2.
Click on “System Status”
3.
Click “Release” then “Renew”
4.
Click “System Tools>Reboot”. Reboot the router and
12
Page 17 / 76
MWN-WAPR150N Wireless Router
try again to confirm access to the internet. If still no
access, continue. If you have access, insert the CD
and follow the prompts.
5.
Click “Advanced Settings>MAC Address Clone”.
Click “Clone MAC Address”.
6.
Click “System Tools>Reboot”. Reboot the router and
try again to confirm access to the internet. If you have
access, insert the CD and follow the prompts. If still no
access, try restarting the computer then contact Tech
Support
–
or
856-216-8222.
2.2 Optimizing Wireless Range
The best possible placement of your wireless router is
nearest the center of your wireless devices. The internal
antenna is omni-directional. Center the router both vertical
and horizontally within the coverage area as much as
possible. The router can be wall-mounted to achieve better
signal as well.
13
Page 18 / 76
MWN-WAPR150N Wireless Router
Chapter 3 How to Login to the Router
This chapter explains how to enter the Router’s Web-based
Graphical User Interface or GUI. After you have finished the
hardware installation, the following steps will assist you to
set the network configurations for you computer.
3.1 How to Set the Network Configurations
1. On your computer desktop right click “
My Network
Places
” and select “
Properties
”.
14
Page 19 / 76
MWN-WAPR150N Wireless Router
2.
Right click “
Local Area Network Connection
” and
select “
Properties
”.
3
．
Select “
Internet Protocol (TCP/IP)
” and click
“
Properties
”.
15
Page 20 / 76
MWN-WAPR150N Wireless Router
4
．
Select “
Obtain an IP address automatically
” and
“
Obtain DNS server address automatically
”. Click
“
OK
” to save the configurations.
Or
select “
Use the following IP address
” and enter the IP
address, Subnet mask, Default gateway as follows:
16
19216811.live