10
Configuration Using the Console Interface
8-Port 10/100/1000 Gigabit Switch with Webview
Chapter 4
Versions
The
Versions
screen displays the Boot Version, Software
Version, Loader Version and the Hardware Version.
Versions
Boot Version
This file runs when the Switch is turned on.
It performs power-on diagnostics and loads the operating
system for the Switch.
Software Version
This file contains the programming
code that runs the Switch.
Hardware Version
The current hardware setup of the
Switch.
General System Information
The
General System Information
screen displays the System
Description, System Up Time, System Mac Address, System
Contact, System Name and System Location.
Select Edit and press the
Enter
key to make changes. When
your changes are complete, press the
Esc
key to return to
the Action menu. Select
Save
and press the
Enter
key to
save your changes. To exit, select
Quit
and press the
Enter
key.
General Information
Management Settings
From the
Management Settings
screen, you can set Serial
Port Session Configuration, Telnet Session Configuration,
or Secure Telnet (SSH) Configuration.
Management Settings
Serial Port Configuration
On the
Serial Port Configuration
screen, the Switch’s baud
rate is displayed.
Select
Edit
and press the
Enter
key to make changes.
Toggle to the desired speed and when your changes are
complete, press the
Esc
key to return to the Action menu.
Select
Save
and press the
Enter
key to save your changes.
To exit, select
Quit
and press the
Enter
key.
Serial Port Configuration
Telnet Configuration
On the
Telnet Configuration
screen, the time-out is
displayed. The value is entered in seconds. If you do not
want the Telnet session to timeout, you may enter a value
of 0 sec.
Select
Edit
and press the
Enter
key to make changes.
When your changes are complete, press the
Esc
key to
return to the Action menu. Select
Save
and press the
Enter
key to save your changes. To exit, select
Quit
and
press the
Enter
key.