Genexis DRG737v2 Router Manual PDF (Setup & Configuration Guide)

Given below is full router user manual of Genexis DRG737v2 router model. You can also download this manual in PDF Format to read later on your computer.

Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.

Page 1 / 12
Quick Installation Guide
DRG700
This guide applies to all DRG700 models
Page 2 / 12
1
Contents
1.
DRG700 overview
............................
2.
Installation
......................................
3.
Network setup
.................................
4.
Wireless setup
.................................
5.
Configuring your DRG700
................
6.
Troubleshooting
..............................
2
4
7
8
9
10
Page 3 / 12
2
1. DRG700 overview
User interfaces
Interface
Description
1
Power port
2
Ethernet LAN
ports
3
USB 2.0 port
4
Telephony ports
5
CATV connector
6
Reset button
7
WPS button
1
3
2
4
5
Note: Depending on your specific
product type, port configuration may
differ.
6
7
Cleaning instructions:
Your DRG700 product may be cleaned using a soft, dry cloth. For areas
of persistent dirt, a damp cloth may be used with mild detergent. Product
and LED logos may be damaged by using aggressive cleaning products or
ethanol-based cleaners - if in doubt do not clean near these logos. Under
no circumstances allow water or cleaning fluid to ingress the product, as
this may cause permanent damage and prevent correct operation.
Page 4 / 12
3
Status feedback LEDS:
LED
Activity
Description
On (green)
On (red)
Blink (green)
Off
Power on
Error
Booting
Power off
On
Off
WAN link active
WAN link inactive
On (green)
On (red)
Off
CATV on, signal received
CATV on, no signal received
CATV disabled
On
Off
Phone line 1 active
Phone line 1 inactive
On
Off
Phone line 2 active
Phone line 2 inactive
On
Blink
Off
WLAN enabled
WPS active
WLAN disabled
LAN
ports
On (green)
On (orange)
Blink
Link operating at 1000
Mbps
Link operating at 100 or 10
Mbps
Activity
Reset button:
Function
Action
Restart
To restart DRG700 without erasing
the saved configuration:
1. Press the button for less than 5
seconds.
2. Release the button.
Factory
reset
To restart DRG700 with all configura-
tion data cleared and factory settings
restored:
1. Press the button for more than 5
seconds.
2. Release the button.
WPS button:
This button is used to automatically connect a
WPS-enabled wireless client to the DRG700. For
details about the connection procedure, see
“Wireless Setup” on page 8.
Page 5 / 12
4
2. Installation
Step 1:
Preparing the DRG FTU
Remove the dust cover from the DRG FTU.
Step 2:
Preparing the DRG700
Remove the dust covers for the fiber connectors
on the DRG700.
Step 3:
Mounting the DRG700 on the DRG FTU
1.
Place the DRG700 on the FTU in such as way
that the tabs on side of DRG700 are aligned
with the cutouts on the FTU.
2.
Gently slide the DRG700 upwards until the fiber
connectors connect firmly with the FTU.

Rate

4.8 / 5 based on 4 votes.

Popular Genexis Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top