Page 101 / 120
Scroll up to view Page 96 - 100
100
Destination
Subnet Mask
Gateway
Hop
Interface
192.168.1.0
255.255.255.0
192.168.123.216
1
LAN
192.168.0.0
255.255.255.0
192.168.123.103
1
LAN
So if, for example, Client3 wants to send an IP data packet to 192.168.0.2 (Client 2), it would use the above table to determine that it
had to go via 192.168.123.103 (Router 2)
And if it sends Packets to 192.168.1.11 (Client 1) will go via 192.168.123.216 (Router 1).
Page 102 / 120
101
8.2.6
Tools
This section allows you to configure some device system settings.
Admin
This page allows you to change the system password and to configure
remote management.
Change Password
Old Password:
Enter the current password.
New Password:
Enter your new password.
Repeat New Password:
Enter your new password again for verification.
Remote Management
Host Address:
You can only perform remote management from the specified IP address. Leave blank to allow any host to
perform remote management.
Port:
Enter the port number you want to accept remote management connections.
Enable:
Tick to Enable the remote management feature.
Page 103 / 120
102
Time
This page allows you to set the system time.
Time
Time Setup:
Select the method you want to set the time.
Time Zone:
Select the time zone for your current location.
NTP Time Server:
Enter the address of the Network Time Protocol (NTP) Server to
automatically synchronize with a server on the Internet.
Daylight Savings:
Check whether daylight savings applies to your area.
Page 104 / 120
103
Dynamic DNS (DDNS)
This free service is very useful when combined with the
Virtual
Server
feature. It allows Internet users to connect to your Virtual
Servers using a URL, rather than an IP Address.
This also solves the problem of having a dynamic IP address.
With a dynamic IP address, your IP address may change
whenever you connect, which makes it difficult to connect to
you.
DDNS Services work as follows:
1.
You must register for the service at one of the listed DDNS Service providers.
2.
After registration, use the Service provider's normal procedure to obtain your desired Domain name.
3.
Enter your DDNS data on the ETR-
9305’s DDNS screen, and enable the DDNS feature.
4.
The Wireless Router will then automatically ensure that your current IP Address is recorded at the DDNS service provider's Domain Name Server.
5.
From the Internet, users will be able to connect to your Virtual Servers (or DMZ PC) using your Domain name, as shown on this screen.
Dynamic DNS
Dynamic DNS
Tick this box to Enable the DDNS feature.
Server Address:
Select the list of Dynamic DNS homes you would like to use from this list.
Username / Password:
Enter the Username and Password of your DDNS account.
Page 105 / 120
104
Power
This page allows you to Enable or Disable the wireless LAN power saving features.
19216811.live