Page 41 / 167
Scroll up to view Page 36 - 40
37
If you wish to backup the
device’s
settings, click “Backup this
configuration” to open a new window and save your current
configuration to a .txt file.
13.
Please wait a moment until the BR-6208AC is ready.
Page 42 / 167
38
14.
A final congratulations screen will indicate that setup is complete. You
can now connect to the device’s new SSID(s) which are shown on the
screen then close the browser window.
15.
The BR-6208AC is working and ready for use. Refer to
IV-2. Connecting
to a Wi-Fi network
if you require more guidance.
Page 43 / 167
39
II-6.
WPS Setup
If your wireless device supports WPS (Wi-Fi
Protected Setup) then you can use this
method to connect to the
BR-6208AC
’s Wi
-Fi
network.
1.
Press the
WPS button
on the BR-6208AC
for 2
–
5 seconds to activate WPS. The
WLAN LED will be lighted on to indicate
that WPS is active.
2.
Within two minutes
, press the WPS
button on the
wireless device/client
to
activate its WPS.
3.
The devices will establish a connection.
Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II-7.
Reset to Factory Default Settings
If you experience problems with your BR-6208AC, you can reset the device
back to its factory settings. This resets
all
settings back to default.
1.
Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the power LED begins to flash.
2.
Release the button when the power LED is
flashing.
3.
Wait for the BR-6208AC to restart. The BR-6208AC is ready for setup when
the power LED, 2.4GHz Wi-Fi and 5GHz Wi-Fi LEDs display
on.
Page 44 / 167
40
III.
Browser Based Configuration Interface
After you have setup the BR-6208AC as detailed in
II. Installation
or the
included
Quick Installation Guide
, you can use the browser based
configuration interface to configure advanced settings.
Please ensure that your computer is set to use a dynamic IP
address. Refer to
IV-1. Configuring your IP address
for more
information.
III-1.
Login
1.
To access the browser based configuration interface enter
http://edimax.setup
into the URL bar of a browser on a network device
connected to the same Wi-Fi network as the BR-6208AC.
If you can not access
http://edimax.setup
, connect the device to a
computer using an Ethernet cable and try again.
2.
You will be prompted for a username and password. The default
username is “admin” and the default password is “1234”.
Page 45 / 167
41
3.
You will arrive at the “
Status
” screen
. Use the menu down the left side to
navigate.
19216811.live