Page 246 / 298
Scroll up to view Page 241 - 245
Vigor2930 Series User’s Guide
238
3.16.2 Routing Table
Click
Diagnostics
and click
Routing Table
to open the web page.
Refresh
Click it to reload the page.
3.16.3 ARP Cache Table
Click
Diagnostics
and click
ARP Cache Table
to view the content of the ARP (Address
Resolution Protocol) cache held in the router. The table shows a mapping between an
Ethernet hardware address (MAC Address) and an IP address.
Refresh
Click it to reload the page.
Clear
Click it to clear the whole table.
Page 247 / 298
igor2930 Series User’s Guide
239
3.16.4 DHCP Table
The facility provides information on IP address assignments. This information is helpful in
diagnosing network problems, such as IP address conflicts, etc.
Click
Diagnostics
and click
DHCP Table
to open the web page.
Index
It displays the connection item number.
IP Address
It displays the IP address assigned by this router for
specified PC.
MAC Address
It displays the MAC address for the specified PC that
DHCP assigned IP address for it.
Leased Time
It displays the leased time of the specified PC.
HOST ID
It displays the host ID name of the specified PC.
Refresh
Click it to reload the page.
3.16.5 NAT Sessions Table
Click
Diagnostics
and click
NAT Sessions Table
to open the setup page.
Private IP:Port
It indicates the source IP address and port of local PC.
Page 248 / 298
Vigor2930 Series User’s Guide
240
#Pseudo Port
It indicates the temporary port of the router used for NAT.
Peer IP:Port
It indicates the destination IP address and port of remote host.
Interface
It displays the representing number for different interface.
Refresh
Click it to reload the page.
3.16.6 Web Authentication Table
This page displays the IP address, UserName and Login Time for the users who passing the
web authentication from this router.
3.16.7 Data Flow Monitor
This page displays the running procedure for the IP address monitored and refreshes the data
in an interval of several seconds. The IP address listed here is configured in Bandwidth
Management. You have to enable IP bandwidth limit and IP session limit before invoke Data
Flow Monitor. If not, a notification dialog box will appear to remind you enabling it.
Click
Diagnostics
and click
Data Flow Monitor
to
open the web page.
Page 249 / 298
igor2930 Series User’s Guide
241
Enable Data Flow
Monitor
Check this box to enable this function.
Refresh Seconds
Use the drop down list to choose the time interval of refreshing
data flow that will be done by the system automatically.
Refresh
Click this link to refresh this page manually.
Index
Display the number of the data flow.
IP Address
Display the IP address of the monitored device.
TX rate (kbps)
Display the transmission speed of the monitored device.
RX rate (kbps)
Display the receiving speed of the monitored device.
Sessions
Display the session number that you specified in Limit Session
web page.
Action
Block
- can prevent specified PC accessing into Internet within 5
minutes.
Unblock
– the device with the IP address will be blocked in five
Page 250 / 298
Vigor2930 Series User’s Guide
242
minutes. The remaining time will be shown on the session column.
Current /Peak/Speed
Current
means current transmission rate and receiving rate for
WAN1/WAN.
Peak
means the highest peak value detected by the router in data
transmission.
Speed
means line speed specified in
WAN>>General
. If you do
not specify any rate at that page, here will display
Auto
for instead.
19216811.live