Page 306 / 335
Scroll up to view Page 301 - 305
Vigor2710 Series User’s Guide
294
Settings in the remote host:
1.
For Win98/ME, you may use "Dial-up Networking" to create the PPTP tunnel to Vigor
router.
For Win2000/XP, please use "Network and Dial-up connections" or “Smart
VPN Client”, complimentary software to help you create PPTP, L2TP, and L2TP over
IPSec tunnel. You can find it in CD-ROM in the package or go to www.draytek.com
download center. Install as instructed.
2.
After successful installation, for the first time user, you should click on the
Step 0.
Configure
button. Reboot the host.
3.
In
Step 2. Connect to VPN Server
, click
Insert
button to add a new entry.
If an IPSec-based service is selected as shown below,
Page 307 / 335
Vigor2710 Series User’s Guide
295
You may further specify the method you use to get IP, the security method, and
authentication method. If the Pre-Shared Key is selected, it should be consistent with
the one set in VPN router.
If a PPP-based service is selected, you should further specify the remote VPN server IP
address, Username, Password, and encryption method. The User Name and Password
should be consistent with the one set up in the VPN router. To use default gateway on
remote network means that all the packets of remote host will be directed to VPN
server then forwarded to Internet. This will make the remote host seem to be working
in the enterprise network.
Page 308 / 335
Vigor2710 Series User’s Guide
296
4.
Click
Connect
button to build connection. When the connection is successful, you will
find a green light on the right down corner.
5.3 QoS Setting Example
Assume a teleworker sometimes works at home and takes care of children. When working
time, he would use Vigor router at home to connect to the server in the headquarter office
downtown via either HTTPS or VPN to check email and access internal database.
Meanwhile, children may chat on Skype in the restroom.
1.
Go to
Bandwidth Management>>Quality of Service.
2.
Click
Setup
link of WAN. Make sure the QoS Control on the left corner is checked.
And select
BOTH
in
Direction
.
Page 309 / 335
Vigor2710 Series User’s Guide
297
3.
Return to previous page. Enter the Name of Index Class 1 by clicking
Edit
link. Type
the name “
E-mail
” for Class 1.
4.
For this index, the user will set reserved bandwidth (e.g., 25%) for
E-mail
using
protocol POP3 and SMTP.
Page 310 / 335
Vigor2710 Series User’s Guide
298
5.
Return to previous page. Enter the Name of Index Class 2 by clicking
Edit
link. In this
index, the user will set reserved bandwidth for
HTTPS
. And click
OK
.
6.
Click
Setup
link for setting reserved bandwidth ratio.
7.
Check
Enable UDP Bandwidth Control
on the bottom to prevent enormous UDP
traffic of VoIP influent other application. Click
OK
.
8.
If the worker has connected to the headquarter using host to host VPN tunnel. (Please
refer to Chapter 3 VPN for detail instruction), he may set up an index for it. Enter the
Class Name of Index 3. In this index, he will set reserved bandwidth for 1 VPN tunnel.
19216811.live