Page 56 / 73
Scroll up to view Page 51 - 55
52
D-Link GO-RT-N150 User Manual
Section 5 - Connecting to a Wireless Network
3. Highlight the wireless network (SSID) you would like to connect to
and click the
Connect
button.
If you get a good signal but cannot access the Internet, check your
TCP/IP settings for your wireless adapter. Refer to the Networking
Basics section in this manual for more information.
4. The following window appears while your computer tries to connect
to the router.
Page 57 / 73
53
D-Link GO-RT-N150 User Manual
Section 5 - Connecting to a Wireless Network
5. Enter the same security key or passphrase that is on your router and
click
Connect
. You can also connect by pushing the WPS button on
the router.
It may take 20-30 seconds to connect to the wireless network. If the
connection fails, please verify that the security settings are correct. The
key or passphrase must be exactly the same as on the wireless router.
Page 58 / 73
54
D-Link GO-RT-N150 User Manual
Section 5 - Connecting to a Wireless Network
Using Windows
®
XP
Windows
®
XP users may use the built-in wireless utility (Zero Configuration Utility). The following instructions are for Service
Pack 2 users. If you are using another company’s utility or Windows
®
2000, please refer to the user manual of your wireless
adapter for help with connecting to a wireless network. Most utilities will have a “site survey” option similar to the Windows
®
XP utility as seen below.
If you receive the
Wireless Networks Detected
bubble, click on the
center of the bubble to access the utility.
or
Right-click on the wireless computer icon in your system tray (lower-
right corner next to the time). Select
View Available Wireless
Networks
.
The utility will display any available wireless networks in your area. Click
on a network (displayed using the SSID) and click the
Connect
button.
If you get a good signal but cannot access the Internet, check you TCP/
IP settings for your wireless adapter. Refer to the Networking Basics
section in this manual for more information.
Page 59 / 73
55
D-Link GO-RT-N150 User Manual
Section 5 - Connecting to a Wireless Network
Configure WPA-PSK
It is recommended to enable WEP on your wireless router or access point before configuring your wireless adapter. If you are
joining an existing network, you will need to know the WEP key being used.
2.
Highlight the wireless network (SSID) you would like to connect to
and click
Connect
.
1.
O p e n t h e Wi n d ow s
®
X P Wi re l e s s U t i l i t y by r i g h t -
clicking on the wireless computer icon in your system tray
(lower-right corner of screen). Select
View Available Wireless
Networks
.
Page 60 / 73
56
D-Link GO-RT-N150 User Manual
Section 5 - Connecting to a Wireless Network
3.
The
Wireless Network Connection
box will appear. Enter the WPA-
PSK passphrase and click
Connect
.
It may take 20-30 seconds to connect to the wireless network. If the
connection fails, please verify that the WPA-PSK settings are correct.
The WPA-PSK passphrase must be exactly the same as on the wireless
router.
19216811.live