You can configure the LAN IP address to suit your preference. Many users will find it convenient to use the default settings together with DHCP service to
manage the IP settings for their private network. The IP address of the Router is the base address used for DHCP. In order to use the Router for DHCP on your
LAN, the IP address pool used for DHCP must be compatible with the IP address of the Router. The IP addresses available in the DHCP IP address pool will
change automatically if you change the IP address of the Router.
Display:
GroupName:
IP Address:
Subnet Mask:
Enable IGMP Snooping:
Standard Mode:
Blocking Mode:
Disable/ Enable DHCP
Server:
Start IP Address:
End IP Address:
Lease Time:
To access the Local Area Network (LAN) Setup
window, click the
LAN
button in the Advanced
Setup directory.
Select the appropriate group name. By default
there is only one group
Enter the LAN IP address for the router here.
Enter the Subnet Mask for the router here.
Tick this option to enable IGMP Snooping.
Select to use Standard Mode. (If IGMP Snooping
is enabled)
Select to use Blocking Mode. (If IGMP Snooping is
enabled)
Choose to enable or disable the DHCP Server
here.
Enter a starting IP Address for the DHCP pool
here.
Enter an end IP Address for the DHCP pool here.
Enter a DHCP Lease Time value here.
To add reserve an IP to a specific host click the
Add Entries
button.
Page 48 / 128
D-Link DSL-2760U USER’S MANUAL
48
Mac Address:
IP Address:
To reserve an IP for a specific host the user must
know the specific host’s Mac Address.
Enter the reserved host’s Mac Address in here.
Enter the reserved host’s IP Address in here.
Click
Apply/Save
to continue.
Static IP Lease List:
All the reserved DHCP client entries will be listed
here.
Second IP Address:
To enable a second LAN interface IP tick this
option and enter a second IP address and Subnet
Mask for the router here.
Note:
The second LAN IP Address must be of a
different IP range than the current first IP Address.
Page 49 / 128
D-Link DSL-2760U USER’S MANUAL
49
NAT – Virtual Servers
Virtual Server allows you to direct incoming traffic from WAN side (identified by Protocol and External port) to the internal server with private IP address on the
LAN side. The Internal port is required only if the external port needs to be converted to a different port number used by the server on the LAN side. The
NAT
button appears when configuring WAN interface in PPPoE,or IPoA.
To Add a Virtual Server Rule, click the
Add
button.
Page 50 / 128
D-Link DSL-2760U USER’S MANUAL
50
Select the
service name
, and enter the
server IP address
and click
Apply/Save
to forward IP packets for this service to the specified server.
NOTE:
The "Internal Port End" cannot be modified directly. Normally, it is set to
the same value as "External Port End". However, if you modify "Internal Port
Start", then "Internal Port End" will be set to the same value as "Internal Port
19216811.live