Page 91 / 103
Scroll up to view Page 86 - 90
Appendix B - Networking Basics
D-Link DSL-2750U User Manual
91
Statically Assign an IP Address
If your DHCP is disabled, or you need to assign a static IP address, please follow the steps below:
Step 1
Windows® XP - Click on
Start
>
Control Panel
>
Network Connections
.
Windows® 2000 - From the desktop, right-click on the
My Network Places
>
Properties
.
Step 2
Right-click on the
Local Area Connection
which represents your D-Link network adapter and select
Properties
.
Step 3
Highlight
Internet Protocol (TCP/IP)
and click on the
Properties
.
Step 4
Click on the
Use the following IP address
and enter an IP address that is on the same subnet as
your network or the LAN IP address on your router.
Example: If the router’s LAN IP address is
192.168.1.1, make your IP address 192.168.1.X where X
is a number between 2 and 99. Make sure that the number you choose is not in use on the network.
Set Default Gateway the same as the LAN IP address of your router (192.168.1.1).
Set Primary DNS the same as the LAN IP address of your router (192.168.1.1). The Secondary
DNS is not needed or you may enter a DNS server from your ISP.
Step 5
Click on the
OK
twice to save your settings.
Page 92 / 103
Appendix C – Technical Specification
D-Link DSL-2750U User Manual
92
Usage of USB Interface
The Combo DSL Gateway is a device with both Ethernet Interface and USB Interface, which is independent, you may use either of them to
connect to the different computers, in this way the two computers can connect to the network at one time.
The Gateway can be seen as a simple
two-port HUB. So, do not connect both the Ethernet Interface and USB Interface to a same computer.
When using USB Interface, you must install the drivers.
After installation, a virtual network card, "USB Remote NDIS Network Device", will be
added into the computer.
It has all the functions of a real network card, and it makes installation more easily.
NOTES:
The following shows the steps for Windows®2000, the installation, configuration and uninstallation of Windows®98 or Windows®XP
are similar to this.
Driver Automatic Installation
There are two files in the DRIVER-CD.
Page 93 / 103
Appendix C – Technical Specification
D-Link DSL-2750U User Manual
93
1.
Run “setup.exe” in DRIVER-CD and click “Next” button.
2.
Click “Install” button to install the driver and wait few seconds.
3.
Click “finish” to complete the install.
4.
Plug in the power cord, and turn on the power.
2
3
1-1
1-2
Page 94 / 103
Appendix C – Technical Specification
D-Link DSL-2750U User Manual
94
5.
Connect USB port of the Gateway to USB port on your PC with the USB cable that comes with the Gateway.
.
6.
System install the drivers automatically.
Notice: If pop up a windows like blow picture, please click “Yes” to allow it.
5
Page 95 / 103
Appendix C – Technical Specification
D-Link DSL-2750U User Manual
95
Driver Automatic Uninstallation
1. Run “setup.exe” in DRIVER-CD and click “Next” button.
2. Click “Yes” button to start uninstall the driver.
3. Click “OK” button completed uninstall the driver.
1
2
3
19216811.live