Enter a user name and the password. The default username and
password of the super user are
admin
and
admin
. The username
and password of the common user are
user
and
user
. You need not
enter the username and password again if you select the option
Remember my password
. It is recommended to change these
default values after logging in to the DSL router for the first time.
Step 4
Click
Login
to log in.
DSL-2730U User Manual
8
Page 12 / 87
4.3
Setup
4.3.1
Wizard
Wizard
enables fast and accurate configuration of Internet connection and other important parameters. The following sections describe these various configuration
parameters.
When subscribing to a broadband service, you should be aware of the method, by which you are connected to the Internet. Your physical WAN device can be Ethernet,
DSL, or both. Technical information about the properties of your Internet connection is provided by your Internet service provider (ISP). For example, your ISP should
inform you whether you are connected to the Internet using a static or dynamic IP address, or the protocol, such as PPPoA or PPPoE, that you use to communicate
over the Internet.
Choose
Setup
>
Wizard
. The page shown in the figure appears.
Click
Setup Wizard
. The page shown in the right figure appears.
DSL-2730U User Manual
9
Page 13 / 87
There are four steps to configure the device. Click
Next
to continue.
Change the password for logging in to the device.
The default password is
admin
. To secure your network, modify the password
timely.
Note:
Confirm password must be the same as the new password.
To ignore the step, click
Skip
.
DSL-2730U User Manual
10
Page 14 / 87
Set the time and date.
First NTP time server
: Select the domain of the time server to which system
time will be synchronized.
Configure the Internet connection.
Select the country and ISP. Set the VPI and VCI. If you fail to find the country
and ISP from the drop-down lists, select
Others
.
Protocol
: The protocol connection type of the interface. You can select
PPPoE, PPPoA, Dynamic IP, Static IP, or Bridge.
Connection Type
: You can select it from the drop-down list according to the
uplink equipment. You can select LLC or VC-Mux.
VPI
: The virtual path identifier of the WAN interface (provided by your ISP).
The range is 0 to 255.
VCI
: The virtual channel identifier for the WAN interface. The range is 32 to
19216811.live