Page 51 / 69
Scroll up to view Page 46 - 50
Section 3 – Configuration
D-Link DSL-2540U User Manual
51
QoS Classification
Choose
Add
or
Remove
to configure network traffic classes.
Use this window to create a traffic class rule to classify the upstream
traffic, assign a queue that defines the precedence and the interface, and
optionally overwrite the IP header DSCP byte. A rule consists of a class
name and at least one condition. Please remember that all of the specified
conditions on this window must be met for the rule to take effect.
Click the
Save/Apply
button to save and activate this rule.
Page 52 / 69
Section 3 – Configuration
D-Link DSL-2540U User Manual
52
Routing
To access the
Routing
windows, click the
Routing
button in the
Advanced Setup
directory.
Default Gateway
If the Enable Automatic Assigned Default Gateway checkbox is ticked, the
Router will accept the first default gateway assignment received from one
of the enabled PPPoA, PPPoE, or MER/DHCP enabled PVC(s).
If this checkbox is not ticked, enter the static default gateway and/or a
WAN interface. Click the
Save/Apply
button when you are finished.
Static Route
Click the
Add
button on the
Routing – Static Route
window to access the
following window displayed on the next page.
Enter the static routing information for an entry to the routing table.
Click the
Save/Apply
button when you are finished.
Page 53 / 69
Section 3 – Configuration
D-Link DSL-2540U User Manual
53
DSL
To access the
DSL Settings
window, click the
DSL Setup
button in the
Advanced Setup
directory.
This window allows you to select the desired modulation, phone line pair,
and capability. Click the
Save/Apply
button when you are finished.
Click the
Advanced Settings
button to select a DSL test mode.
Page 54 / 69
Section 3 – Configuration
D-Link DSL-2540U User Manual
54
Select the desired DSL test mode and then click the
Apply
button.
Click the
Tone Selection
button to modify the upstream and downstream
tones.
Select the appropriate upstream and downstream tones for your ADSL
connection. Click the
Apply
button to let your settings take effect
.
Page 55 / 69
Section 3 – Configuration
D-Link DSL-2540U User Manual
55
PPTP
To access the
PPTP Setting
window, click the
PPTP
button in the
Advanced Setup
directory.
To set up Point-to-Point Tunnel Protocol, tick the Enable check box, enter
the appropriate information in the fields offered, and then click the
Save/Apply
button when you are finished.
Interface Group
Interface Group supports multiple ports to PVC and bridging groups. Each group will perform as an independent network.
To support this feature, you must create mapping groups with appropriate
LAN and WAN interfaces using the Add button. The Remove button will
remove the grouping and add the ungrouped interfaces to the Default
group. Only the default group has IP interface.
Choose
Enable virtual ports on eth0
button and click
Add
to do
advanced settings.
19216811.live