Page 51 / 64
Scroll up to view Page 46 - 50
51
D-Link DSL-±3±0B ADSL±+ Ethernet/USB Modem User Manual
Section 10 - Status
Log
This is the same screen as seen in the Remotelog section under tools.
LAN
The LAN section shows received and transmitted packet information for the Ethernet interface. Click on
Reset Statistics
to renew the information.
Page 52 / 64
5±
D-Link DSL-±3±0B ADSL±+ Ethernet/USB Modem User Manual
Section 10 - Status
WAN
The WAN section shows received and transmitted packet information for the WAN connections that you have set up.
Click on
Reset Statistics
to renew the information.
Page 53 / 64
53
D-Link DSL-±3±0B ADSL±+ Ethernet/USB Modem User Manual
Section 10 - Status
The ATM section displays statistical values for your ATM interface as well as for AAL5 and AAL5 VCC. Click on
Reset
Statistics
to reset the values.
ATM
Page 54 / 64
54
D-Link DSL-±3±0B ADSL±+ Ethernet/USB Modem User Manual
Section 10 - Status
Information contained in the ADSL screen is useful for troubleshooting and diagnosing connection problems.
ADSL
Page 55 / 64
55
D-Link DSL-±3±0B ADSL±+ Ethernet/USB Modem User Manual
Section 10 - Status
A Bit Error Rate Test (BER Test) is a test that reflects the ratio of error bits to the total number transmitted.
ADSL BER Test
If you click on the
ADSL BER Test
button at the bottom of the ADSL Statistics
page, the following pop-up screen will appear allowing you to set the tested
time and to begin the test. Click
Start
to begin the test.
When you start the ADSL BER Test, the following progress window will display
the connection speed as well as the length of time that the test will run for.
At any time during the test, click on the
Stop
button to terminate the test.
19216811.live