D-Link DIV-140 Router Manual PDF (Setup & Configuration Guide)
Given below is full router user manual of D-Link DIV-140 router model. You can also download this manual in PDF Format to read later on your computer.
Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.
Page 1 / 12
Page 2 / 12
±
D-Link DIV-140 Quick Install Guide
Package Contents
System Requirements
If any of the above items are missing, please contact your reseller.
• Computers with Windows
®
, Macintosh
®
, or Linux-based operating systems
and an installed Ethernet Adapter
• Internet Explorer version 6.0 or Netscape Navigator 7.0 or higher
(for configuration)
• D-Link DIV-140 VoIP Gateway
• Power Adapter
• CAT5 Ethernet Cable
• RJ-45 to DB-9 Cable
• Four (4) RJ-11 Cables
• CD-ROM with Installation Guide, User Manual, and Special Offers
Note: Using a power supply with a different voltage than the one included with
the DIV-140 may damage the unit and will void the warranty for this product.
Page 3 / 12
²
D-Link DIV-140 Quick Install Guide
Connecting the DIV-140 to your network
B. LAN Port
Connects DIV-140
to Ethernet enabled
device or switch.
A.
Connect the power adapter to the receptor on the rear panel of
the
DIV-140 and then plug the other end of the power adapter to a wall
outlet or power strip. The power LED will turn ON to indicate proper
operation.
A. Power Receptor
Receptor for Power
Adapter.
B
.
C
.
Connect the RJ-45 to DB-9 Console Cable from the Console port on the
DIV-140 to the Com Port on the computer that will be used to configure
the DIV-140.
Connect the LAN interface to the hub or switch connected to your internal
network using a CAT5 Ethernet cable. The LAN LED on the front of the
device should illuminate when a connection is made.
C. Console
Used to connect the
DIV-140 to the Com Port on
your computer.
PSTN Ports
Four (4) FXO ports used to
connect to wall phone jacks.
Reset Button
Press to reset the
DIV-140 to factory
default settings.
Page 4 / 12
4
D-Link DIV-140 Quick Install Guide
Configuring the DIV-140
The terminal settings should
be
115200
8-N-1-N
.
With the console cable connected from the Console port of the DIV-140
to the Com port of your PC, launch the HyperTerminal program:
A computer on your LAN must be assigned an IP address and subnet mask
in the same range as the DIV-140. By default, the DIV-140 is assigned an IP
address of
10.0.0.1
with a subnet mask of
255.0.0.0
. It can be configured in
two ways, through the web interface or command line interface (CLI).
Enter
admin
for the Username and
password
for the
Password.
Power on the DIV-140, after the device boots up, login when prompted:
Page 5 / 12
³
D-Link DIV-140 Quick Install Guide
It may be necessary to change the IP address of the DIV-140 to match
your local network. To change the IP address of the DIV-140, use the
19216811.live