Page 11 / 83 Scroll up to view Page 6 - 10
11
D-Link DIR-615 User Manual
Section ² - Configuration
Configuration
This section will show you how to configure your new D-Link wireless router using the web-based configuration
utility.
Web-based Configuration Utility
To access the configuration utility, open a web-browser
such as Internet Explorer and enter the IP address of
the router (192.168.0.1).
Select
Admin
from the drop-down menu and then enter
your password. Leave the password blank by default.
If you get a
Page Cannot be Displayed
error, please
refer to the
Troubleshooting
section for assistance.
Page 12 / 83
D-Link DIR-615 User Manual
Section ² - Configuration
Setup Wizard
You may click
Setup Wizard
to quickly configure your router.
If you want to enter your settings without running the wizard, click
Manual Configuration
and skip to page 16.
Click
Launch Internet Connection Setup Wizard
to begin.
If you want to configure your wireless settings, click
Launch Wireless
Security Setup Wizard
and skip to page 49.
Page 13 / 83
D-Link DIR-615 User Manual
Section ² - Configuration
Click
Next
to continue.
Create a new password and then click
Next
to continue.
Select your time zone from the drop-down menu and then click
Next
to continue.
Select the type of Internet connection you use and then click
Next
to continue.
Page 14 / 83
D-Link DIR-615 User Manual
Section ² - Configuration
If you selected Dynamic, you may need to enter the MAC address of the
computer that was last connected directly to your modem. If you are currently
using that computer, click
Clone Your PC’s MAC Address
and then click
Next
to continue.
The Host Name is optional but may be required by some ISPs. The default
host name is the device name of the Router and may be changed.
If you selected PPPoE, enter your PPPoE username and password. Click
Next
to continue.
Select
Static
if your ISP assigned you the IP address, subnet mask, gateway,
and DNS server addresses.
Note:
Make sure to remove your PPPoE software from your computer. The
software is no longer needed and will not work through a router.
If you selected PPTP, enter your PPTP username and password. Click
Next
to continue.
Page 15 / 83
15
D-Link DIR-615 User Manual
Section ² - Configuration
If you selected L2TP, enter your L2TP username and password. Click
Next
to continue.
If you selected Static, enter your network settings supplied by your Internet
provider. Click
Next
to continue.
Click
Connect
to save your settings. Once the router is finished rebooting,
click
Continue
. Please allow 1-2 minutes to connect.
Close your browser window and reopen it to test your Internet connection.
It may take a few tries to initially connect to the Internet.
If you selected Big Pond, select your authentication server from the drop
down menu. You will also need to enter your Big Pond username and
password. Click
Next
to continue.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top