28

Trunk Setting

The Trunk function enables to cascade two devices with a double

times bandwidth (maximum up to 24Gbps in full duplex mode).

There are three selections in each group of trunk setting as follow:

Group 1: Selection 1(disable), Selection 2(port 1, 2), Selection 3(port 1, 2, 3, 4).

Group 2: Selection 1(disable), Selection 2(port9, 10), Selection 3(port 9, 10, 11, 12)

Group32: Selection 1(disable), Selection 2(port17, 18), Selection 3(port 17, 18, 19, 20)

.

Figure 21. Trunk Settings

Be sure that the selected trunk setting port must connect to the device

with a same VLAN group.

Mirror Setting

Port Mirroring is a method of monitoring network traffic that forwards

a copy of each incoming and/or outgoing packet from one port of a

network switch to another port where the packet can be studied. It

enables the manager to keep close track of switch performance and

alter it if necessary.

Configuring the port Mirroring by assigning a source port from which

to copy all packets and a sniffer port where those packets will be sent.

The selection of the sniffer mode is as follow:

RX (receive) mode:

this mode will duplicate the data that send to the

source and forward to the sniffer port.

29

Figure 22.

Device Status

Click on the

“Status”

to present the device status on this screen, it will

show the System Status, Port Status, VLAN Status, Trunk Status and

Mirror Status..

Press

“Refresh”

when you need to renew the posted information.

Statistic

The Statistic Menu screen will show the status of each port packet

count.

Figure 23. Statistic

30

For Detail packet information, click on the ID parameter as Figure 24.

Figure 24.

System Setting

The System Setting includes the System name, Location name, Login

Timeout, IP Address, Subnet Mask and Gateway. Through the Web

Management Utility, you can easily recognize the device by using the

System Name and the Location Name.

The Login Timeout is to set the idle time-out for security issue, when

there is no action in running the Web Smart Utility and the time is up,

you must re-login to Web Smart Utility before you set the Utility.

Fill up the IP Address, Subnet Mask and Gateway for the device.

31

Figure 25.

Trap Setting

The Trap Setting enables the device to monitor the Trap through the

Web Management Utility, set the Trap IP Address of the manager

where the trap to be sent.

Figure 26. Trap Setting

u

System Events:

Monitoring the system’s trap.

Device Bootup:

a trap when booting up the system.

Illegal Login:

a trap when there is using a wrong password login,

and it will record from where the IP to be login.

u

Twisted Pair Port Events:

Monitoring the copper port status.

Abnormal* Receive Error:

a trap when there are receive data

error in copper port.

32

Abnormal* Transmit Erro

r: a trap when there are transmit data

error in copper port.

Abnormal*: 50 error packet count within 10 seconds.

Set Password

Password is the invaluable tool for the manager to secure Web

Management Switch, use this function to change the password.

If you forget the password, press the “Reset” button in the rear panel

of the Switch, the current setting includes VLAN, Port Setting…

etc.

will be lost and the Switch will restore to the default setting.

Figure 27. Set Password

Backup Setting

The backup tools help you to backup the current setting of the Switch.

Once you need to backup the setting, press the

“Backup”

button to

save the setting.

To restore a current setting file to the device, you must specify the

backup file and press

“Restore”

button to proceed the setting of the

recorded file.