Page 16 / 98
Scroll up to view Page 11 - 15
16
The IP Address of your camera must
correspond with your network settings
for you to access the camera. If you are
unsure of what these settings should
be, please check with your network
administrator.
By default, the Admin ID and Password
are blank. If you are running this Setup
Wizard for the first time, leave both
Admin ID and Password fields blank
and simply click OK to continue. If you
changed the Admin ID and Password,
enter them and click OK to continue.
This screen appears if the default IP
Address of the camera (192.168.0.20)
does not correspond with your local
area network settings. You must assign
an IP address for your camera that
corresponds to your network’s IP
addressing scheme.
Click
Yes
Click
OK
Click
OK
Using the Setup Wizard
(continued)
If you change any of the default settings in the Setup Wizard, the following screens
may appear:
Page 17 / 98
17
Web Configuration
After completing the Setup Wizard, you are ready to use your camera. The Web
configuration utility is designed to easily access and configure your DCS-900W.
If you would like to open the configuration page from a Web Browser, enter the IP
address that you assigned to your DCS-900W.
Note:
The PC’s IP address must correspond with the DCS-900W’s IP address in the same
segment (i.e. PC=192.168.0.5, Camera=192.168.0.20) for the two devices to
communicate. For instructions on how to do this, please access instructions for
installing any of the D-Link Broadband Gateway products from
support.dlink.com/
products.
Home Screen
After the camera’s IP address is entered in the Browser, the DCS-900W Home screen
will appear with a still image from your camera. There will be three options to choose
from to set up and view your Internet Camera:
!
ActiveX
!
Java
!
Setup
DCS-900W Configuration
Page 18 / 98
18
Configuration
Click on
Setup
from the Home screen to access the settings required for the DCS-
900W.
DCS-900W Configuration
(continued)
There will be several options in the Configuration page to choose from to setup your
DCS-900W and they are as follows
:
Advanced
•
System
•
Video
Tools
•
Admin
•
Time
•
Default
Status
Help
Page 19 / 98
19
Advanced > System
The System menu allows you to configure and set up your
DCS-900W for operation. If
you already set up your camera using the Setup Wizard, you may view/change your
settings here.
To access the System menu, click on the
Advanced Tab
in the menu bar, then the
System
tab in the left hand bar and the
System
screen will appear as illustrated below:
DCS-900W Configuration
(continued)
Page 20 / 98
20
DCS-900W Configuration
(continued)
Advanced > System
The default settings are as follows:
!
!
Subnet Mask – 255.255.255.0
!
Default Gateway – 0.0.0.0
Camera Name:
This field is used for entering a descriptive name for the camera. The default setting for
the Camera Name is CS-xxxxxx, where xxxxxx are the last six digits of the MAC
Address. The maximum length is 32 characters (Printable ASCII).
Location:
This field is used for entering a descriptive name for the location used by the DCS-
900W.
IP Assignment:
There are two options to select from the IP Assignment, either
Manually Assign
or
Assign Automatically Using
.
Manually Assign
You can click
Manually Assign
and directly enter a valid IP Address for your camera.
Remember that your camera’s IP Address must correspond to your network settings
if you wish to change it here.
Important Information
Access to the Internet Camera is gained by assigning a proper IP Ad-
dress.
Please make sure to use a vacant IP address when you assign the
IP Address for the Internet Camera.
This will prevent IP Address conflicts.
19216811.live