16

DCS-6620G User’s Manual

D-Link Systems, Inc.

Installation Wizard Screen

Network

Settings:

Here users can configure the Network

Settings for the camera. Enter the IP

address, Subnet mask, Default router

IP, Primary DNS, and Secondary

DNS. Automatically, the option to

reset IP address at boot is selected.

If you would like to save your IP

address settings, make sure to

uncheck this box.

Setup

On the initial Setup Screen you can configure

System and Date/Time settings for each camera.

Click

Next

to configure Network settings for the

camera.

System

Settings:

Enter a Camera Name and create an

Admin password for the camera.

Date/Time

Settings:

Enter the Date and Time for each

camera. These settings can also

be configured on the

Tools > System

screen (page 57) when configuring

the camera via a Web browser.

Here users can configure the

Wireless Network Settings for the

camera. Enter the SSID and select

the Wireless mode, Channel, Tx

Rate, and Preamble. Check the

Data Encryption box to enable data

encryption and configure the settings.

These settings are explained and can

also be configured on the

Advanced

> Network

screen (page 38) when

configuring the camera via a Web

Browser.

Wireless

Network

Settings:

17

DCS-6620G User’s Manual

D-Link Systems, Inc.

Installation Wizard Screen

Reset to Default

Click the Reset to Default tab to reset the camera’s settings to factory defaults.

About

Click About to display the current version and date

of the Installation Wizard.

Exit

Click the Exit tab to exit the Installation Wizard screen.

Upgrade

The upgrade window allows users to upload a

saved firmware file. If the firmware is older than

that currently on the camera, a screen will appear

indicating so and prompting the user to confirm

the upload.

This displays information about

the firmware and plugin currently

installed on the camera.

Allows you to browse to the location

of the firmware to be uploaded to

the camera.

This displays the file name of the

firmware selected for upload.

Package

Information:

Locate the

Firmware to

Upgrade:

Selected

Package:

Click Next and then

Apply

to save the configured

settings. Users can click

Previous

to modify

changes or mistakes.

18

DCS-6620G User’s Manual

D-Link Systems, Inc.

Enabling UPnP

TM

for Windows

®

XP

Enabling UPnP

for Windows

®

XP

UPnP

TM

is short for Universal Plug and Play, which is a networking architecture that provides

compatibility among networking equipment, software, and peripherals. The

DCS-6620G

is a

UPnP enabled 802.11g PTZ Internet Camera. If your operating system is UPnP enabled,

the device will be easier to configure. If you do not want to use the UPnP functionality, it can

be disabled by unselecting “

Enabled

” on the DDNS/UPnP settings page under “Advanced” in

the configuration menu. Use the following steps to enable UPnP (Universal Plug and Play)

settings only if you are running Windows XP. If you are running Windows 2000, UPnP is not

available.

Click

Control Panel



Go to

Start > Settings

.

Click

TM

19

DCS-6620G User’s Manual

D-Link Systems, Inc.

Enabling UPnP

TM

for Windows

®

XP

Click

Add/Remove Windows

Components

The following screen will appear:

Select

Networking Services

Click

Details

Select

Universal Plug

and Play

Click

Ok

20

DCS-6620G User’s Manual

D-Link Systems, Inc.

Enabling UPnP

TM

for Windows

®

XP

Please wait while Setup configures the

components.

Click

Next

Click

Finish