Page 16 / 138
Scroll up to view Page 11 - 15
16
DCS-2100 User’s Manual
D-Link Systems, Inc.
Installation Wizard
To access the Installation Wizard screen, click on the Installation Wizard Icon on your
desktop.
The opening Installation Wizard screen will appear and show a MAC address of the
DCS-2100
and an IP Address (which may or may not be correct depending on what
you have your
DCS-2100
connected to). If you have a DHCP* server on your network,
there will be a valid IP Address displayed here, indicated by a “Yes” under the assigned
column.
*A DHCP server is a device that supplies IP Addresses to its clients that are on the
same network.
Installation is now complete. Click
Finish
.
Page 17 / 138
17
DCS-2100 User’s Manual
D-Link Systems, Inc.
Installation Wizard
IMPORTANT:
A hardware reset of the Internet Camera may be required if the
Installation Wizard
cannot find the camera. To accomplish this reset, press the reset hole on the back of the
camera (see page 126 for the location of the reset hole). The LED on the front of the
camera will begin blinking red and blue. When it stops the blinking cycle continue to
hold in the reset button until a second cycle of blinking red and blue lights indicates a
second reset cycle has completed. This will take approximately 5-7 seconds.
Page 18 / 138
18
DCS-2100 User’s Manual
D-Link Systems, Inc.
Installation Wizard
The
Installation Wizard
will now show a MAC address for the
DCS-2100
and an IP
address. This IP address may not be correct at this step in the installation until you see
“Yes” under the assigned column. The camera is now automatically configured with an
IP address consistent to the device it is connected to.
Select the MAC address. Click on the
Link to Selected Devices
button.
For more information regarding the functions of this screen, see the following section
titled “Installation Wizard Screen.”
Page 19 / 138
19
DCS-2100 User’s Manual
D-Link Systems, Inc.
Installation Wizard
After you click on the
Link to Selected Devices
button,
Installation Wizard
will
automatically open your Internet browser to the IP Address of the
DCS-2100
in this
DCS-2100
may have a different IP Address.
Page 20 / 138
20
DCS-2100 User’s Manual
D-Link Systems, Inc.
Installation Wizard
You have now completed the Setup Wizard and are ready to use your camera! You can
also continue to the section titled “Installing IP surveillance Software” (page 31) to install
the IP surveillance software before you begin to use the DCS-2100.
Enter the administrative password. Click
Save
and then the “
X
” at the top right-hand
corner of your browser to close the page.
At this point we highly recommend that you click on
Configuration
,
Tools
,
Admin
,
and enter in a password for security purposes.
19216811.live