Page 16 / 103
Scroll up to view Page 11 - 15
DG-BG4300N User Manual
Step 7
: If the LED indications are proper click ‘
Next
’ to continue with the installation.
Step 8
: Here, you can configure the ADSL router. Select the Country : India and then select the service
provider from the drop-down list. You can change the VPI/VCI value as instructed by your ISP.
Page 17 / 103
DG-BG4300N User Manual
VPI : The valid value is in the range of 0 to 255
VCI : The valid value is in the range of 32 to 65535. (0 to 31 is reserved for local management of
ATM traffic).
Note
:
If ISP you are looking for is not listed in the dropdown list, then you can add the parameters manually,
select ‘
User defined’
in the Country and enter the Service Provider with correct VPI/VCI values.
Page 18 / 103
DG-BG4300N User Manual
Step 9
: Click ‘
Next’
to continue with the installation.
You can select
LLC
or
VC-Mux
as the encapsulation mode according to the uplink equipment or use the
default setting.
1483 Bridged
: If you select 1483 Bridged as the WAN protocol, you must use the third party
Dial-up software or Windows New Connection Wizard to configure the Internet dial-up access.
1483 MER
: If you select 1483 MER as the WAN protocol, the router obtains an IP address
automatically.
1483 Routed
: If you select 1483 Routed as the WAN protocol, you can not use the DHCP
service. You need to enter the IP address, subnet mask, default gateway and DNS that is
provided by your ISP.
PPPoE /PPPoA
: If you select PPPoE or PPPoA as the WAN protocol, click
Next
, and the
following page appears.
Step 10
: In this page, enter the correct user ID and password that is provided by your ISP.
After settings, click ‘
Next’
to continue with the installation.
Page 19 / 103
DG-BG4300N User Manual
Following page appears showing the WAN status.
Page 20 / 103
DG-BG4300N User Manual
Note
:
If the WAN IP address appears 0.0.0.0, then click Retry for retrying the connection to Internet. If a valid
IP address appears, other than 0.0.0.0, then click Finish to complete the configuration.
Click ‘
Next
’ to continue with the installation.
Step 11
: In this page, you can set the SSID for wireless network.
Step 12
: Click ‘
Next’
and the following page appears. In this page, you can select WEP or WPA-PSK
/WPA2-PSK as the security mode. Enter 5 characters for WEP key. And enter 8~63 characters for WPA-
19216811.live