Page 26 / 75 Scroll up to view Page 21 - 25
9. After clicking
Save/Reboot
, the router will save the configuration to the flash
memory, and reboot.
The Web UI will not respond until the system is brought up
again.
After the system is up, the Web UI will refresh to the Device Info page
automatically.
The CT-5071 is ready for operation and the LEDs display as described
in the LED description tables.
25
Page 27 / 75
z
Bridging
Select the bridging mode.
To configure Bridging, do the following.
1. Select Quick Setup and click
Next
.
2. Enter the PVC Index and click
Next
.
3. Type in the VPI and VCI values provided by the ISP and click Next.
4. Select the Bridging radio button and click
Next
.
The following screen appears.
To use the bridge service, tick the checkbox, Enable Bridge Service, and enter
the service name.
5. Click the
Next
button to continue.
Enter the IP address for the LAN interface.
The default IP address is 192.168.1.1.
The LAN IP interface in bridge operating
mode is needed for local users to manage the ADSL router.
Notice that there is
no IP address for the WAN interface in bridge mode, and the remote technical
support cannot access the ADSL router.
26
Page 28 / 75
6. Click the
Next
button
The following screen will be displayed.
The WAN Setup-Summary screen presents the entire configuration
summary.
Click
Save/Reboot
if the settings are correct.
Click
Back
if you wish to modify the settings.
27
Page 29 / 75
Chapter 5
Device Info
After login, the
Device Info
screen appears as shown.
Note:
The selections available on the left side of menu are based upon the
configured connection.
28
Page 30 / 75
5.1 WAN
Click
WAN
on the Device Info menu bar to display the configured PVC(s) and the
status.
VPI/VCI
Shows the values of the ATM VPI/VCI
Con. ID
Shows the connection ID
Category
Shows the ATM service classes
Service
Shows the name for WAN connection
Interface
Shows connection interfaces
Protocol
Shows the connection type, such as PPPoE, PPPoA, etc.
IGMP
Shows the statue of the IGMP function
QoS
Shows the statue of the QoS function
State
Shows the connection state of the WAN connection
Status
Lists the status of DSL link
IP Address
Shows IP address for WAN interface
29

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top