Page 46 / 75
Scroll up to view Page 41 - 45
6.3.3 DMZ Host
Note:
This option is not available for Bridge mode.
The DSL router will forward IP packets from the WAN that do not
belong to any of the applications configured in the Virtual Servers
table to the DMZ host computer.
Enter the computer's IP address and click "Apply" to activate the DMZ
host.
Clear the IP address field and click "Apply" to deactivate the DMZ host.
45
Page 47 / 75
6.4 Security
6.4.1 Parental Control
Click on Parental Control in the menu bar.
Then click Add.The following screen will be displayed.
Input your User Name. Select the day of the week and the time that
you want the restriction in place (as shown below).
46
Page 48 / 75
Then click Save/Apply. The following screen will be displayed.
6.4.2 MAC Filtering
Mac Filtering is only available for Bridged mode.
Each network device has a unique MAC address.
You can block or
forward the packets based on the MAC addresses.
The MAC Filtering
Setup screen allows setting up the MAC filtering policy and the MAC
filtering rules. MAC Filtering is only effective on ATM PVCs configured
in Bridge mode.
The policy
FORWARDED
means that all MAC layer frames will be
FORWARDED
except those matching with any of the specified rules in
the following table.
BLOCKED
means that all MAC layer frames will be
BLOCKED
except those matching with any of the specified rules in the
following table.
The default is FORWARD; you change by clicking the
Change Policy
button.
47
Page 49 / 75
Choose
Add
or
Remove
to configure MAC filtering rules.
The
following screen pops up when you click
Add
.
Create a filter to
identify the MAC layer frames by specifying at least one condition
below. If multiple conditions are specified, all of them take effect. Click
Apply
to save and activate the filter.
Option
Description
Protocol type
PPPoE, IPv4, IPv6, AppleTalk, IPX, NetBEUI,
IGMP
Destination MAC
Address
Define the destination MAC address
Source MAC Address
Define the source MAC address
48
Page 50 / 75
Set Multicast
Click this button, it will automatically set the
multicast MAC address.
From Interface
Select the incoming packet interface
To Interface
Select the outgoing packet interface
6.4.3
IP Filtering
This option is only available for PPPoE and PPPoA.
IP filtering allows you to create a filter rule to identify
outgoing/incoming IP traffic by specifying a new filter name and at
least one condition below. All of the specified conditions in this filter
rule must be satisfied for the rule to take effect. Click 'Save/Apply' to
save and activate the filter.
Outgoing
To add a filtering rule, simply click the Add button. The following
screen will be displayed.
49
19216811.live