Billion BiPAC 7800NXL Router Manual PDF (Setup & Configuration Guide)

Page 106 / 170 Scroll up to view Page 101 - 105

103

Then in the Add Network Traffic Class Rule page, enter the information to set up a rule to your

needs. To Assign Classification queue, select the needed WAN queue.

3. Click

Apply

to save your settings and the added rule will be listed as below.

Page 107 / 170

104

Routing

Default Gateway

To set default gateway and Available Routed WAN Interface. This interfaces are the ones you have

set in WAN section, here select the one you want to be the default gateway by moving the interface

via

or

. And select a Default IPv6 Gateway from the drop-down menu.

Note:

Only one default gateway interface will be used according to the priority with the first being the

highest and the last one the lowest priority if the WAN interface is connected.

Page 108 / 170

105

Static Route

With static route feature, you are equipped with the capability to control the routing of the all the

traffic across your network. With each routing rule created, you can specifically assign the

destination where the traffic will be routed to.

Above is the static route listing table, click Add to create static routing.

IP Version:

select the IP version, IPv4 or IPv6.

Destination IP Address / Prefix Length:

enter the destination IP address and the prefix length. For

IPv4, the prefix length means the number of ‘1’ in the submask, it is another mode of presenting

submask. One IPv4 address,192.168.1.0/24, submask is 255.255.255.0. While in IPv6, IPv6

address composes of two parts, thus, the prefix and the interface ID, the prefix is like the net ID in

IPv4, and the interface ID is like the host ID in IPv4. The prefix length is to identify the net ID in the

address. One IPv6 address, 3FFE:FFFF:0:CD30:0:0:0:0 / 64, the prefix is

3FFE:FFFF:0:CD3.

Interface:

select an interface this route associated.

Gateway IP Address:

enter the gateway IP address.

Metric:

Metric is a policy for router to commit router, to determine the optimal route. Enter one

number greater than or equal to 0.

Click

Apply

to apply this route and it will be listed in the route listing table.

Page 109 / 170

106

In listing table you can remove the one you don’t want by checking the checking box and press

Remove

button.

Page 110 / 170

107

Policy Routing

Here users can set a route for the host (source IP) in a LAN interface to access outside through a

specified Default Gateway or a WAN interface.

The following is the policy Routing listing table.

Click

Add

to create a policy route.

Policy Name:

user-defined name.

Physical LAN Port:

select the LAN port.

Source IP:

enter the Host Source IP.

Interface:

select the WAN interface which you want the Source IP to access outside through.

Default Gateway:

enter the default gateway which you want the Source IP to access outside

through.

Click

Apply

to apply your settings. And the item will be listed in the policy Routing listing table. Here

if you want to remove the route, check the remove checkbox and press Remove to delete it.

Rate

Popular Billion Models

Famous Router IPs

Famous Router Companies

Bookmark Our Site

Share