Page 91 / 211
Scroll up to view Page 86 - 90
87
WPS Setup
WPS (Wi-Fi Protected Setup) feature is a standard protocol created by Wi-Fi Alliance. WPS is used
to exchange the AP setting with Station and configure Ap settings. This feature greatly simplifies the
steps needed to create a Wi-Fi network for a residential or an office setting. The commonly known
PIN method
is supported to configure WPS.
WPS:
Select enable to enable WPS function. Please note that WPS can only be available when
WPA2-PSK or OPEN mode is configured.
Note:
1) WPS feature is only available when in WPA2 or OPEN mode in security settings.
2) Here wireless can be configured as
Registrar
and
Enrollee
mode respectively. When AP is
configured as Registrar, you should select “Configured” in the WPS AP Mode below, and default
WPS AP Mode is “Configured”. When AP is configured as Enrollee, the WPS AP Mode below
should be changed to “Unconfigured”. Follow the following steps.
Page 92 / 211
88
Configure AP as Registrar
Add Enrollee with PIN method
1. Select radio button “
Enter STA PIN
”.
2. Input PIN from Enrollee Station (16837546 in this example), Or else users can
alternatively
enter the authorized station MAC
Help:
it is to help users to understand the concept and correct
operation.
3.
Click
.
(Station PIN)
(Station MAC)
Note:
Users can
alternatively
input PIN from Enrollee Station or enter the authorized station MAC.
Page 93 / 211
89
4. Operate Station to start WPS Adding Enrollee. Launch the wireless client’s WPS utility (eg.Ralink
Utility). Set the Config Mode as Enrollee, press the WPS button on the top bar, select the AP (eg.
Wlan-ap-2.4g) from the WPS AP List column. Then press the PIN button located on the middle
left of the page to run the scan.
Page 94 / 211
90
4. The client’s SSID and security settings will now be configured to match the SSID and security
settings of the registrar.
You can check the message in the red ellipse with the security parameters you set, here we all use
the default.
Page 95 / 211
91
Configure AP as Enrollee
Add Registrar with PIN Method
1. Set AP to “
Unconfigured Mode
” and Click “
Config AP
” button.
19216811.live