Page 11 / 139
Scroll up to view Page 6 - 10
8
1.3 Applications of the BiPAC 7300W
Page 12 / 139
9
Chapter 2
Product Overview
2.1 Important Notes
9
Place the router on a stable surface.
9
Only use the power adapter that comes with the package. Using
a different voltage rating power adaptor may damage the router.
Attention
9
Do not use the router in high humidity or high temperatures.
9
Do not use the same power source for the router as other
equipment.
9
Do not open or repair the case yourself. If the router is too hot,
turn off the power immediately and have it repaired at a
qualified service center.
9
Avoid using this product and all accessories outdoors.
Warning
Page 13 / 139
10
2.2 Package Contents
BiPAC 7300W Wireless-N ADSL2+ Firewall Router
CD-ROM containing the online manual
RJ-11 ADSL/telephone Cable (1.8M)
Ethernet (CAT-5 LAN) Cable (1.8M Straight)
Power Adapter (12V DC, 1A)
Quick Start Guide (105*150 mm)
Antennas (1 pcs)
Page 14 / 139
11
2.3 The Front LEDs
LED
Meaning
1
Power
Lit red while the flash is damage and cannot bring the system
up.
Lit green when the system is ready.
Flashes green when the
the system is rebooting or firmware
upgrading.
2
Ethernet
Port 1 - 4
Lit when connected to an Ethernet device.
Green for 100Mbps; Orange for 10Mbps.
Blinking when data is Transmitted / Received.
3
Wireless
Lit green when the wireless connection is established.
Flashes when sending/receiving data.
4
WPS
Blinking when WPS is in progress.
5
DSL
Lit green when successfully connected to an ADSL DSLAM
(“linesync”).
6
Internet
Lit red when WAN port fails to get IP address.
Lit green when WAN port gets IP address successfully.
Page 15 / 139
12
2.4 The Rear Ports
Port
Description
1
Antenna
Connect the antenna to this port.
2
ON/OFF
Power ON/OFF switch.
3
Power
Connect the supplied power adapter to this jack.
4
Reset
After the router is powered on, press this reset button using the
end of paper clip or other small pointed object for 6 seconds and
above to restore it to factory default settings.
1. Recovery procedures for non-working routers (e.g. after a
failed firmware upgrade flash).
2. Recovery procedures for a lost web interface password.
5
WPS
Press the WPS button acoording to the following two to achieve
different functions.
2-5 seconds: start WPS.
5 seconds above: switch to enable/disable WLAN.
6
Ethernet
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
Note: Only Ethernet port 1 can be used for EWAN.
7
DSL
Connect the supplied RJ-11 (“telephone”) cable to this port when
connecting to the ADSL/telephone network.
19216811.live