19216811.liveRTA04N User
’
s Manual
Ed.0.1
Page 51 of 78
Figure 4-32
Src IP:
The source IP address of the rule.
Src Mask:
The source mask of the rule.
Dest IP:
The destination IP address of the rule.
Dest Mask:
The destination mask of the rule.
Src Port:
The source port number of the rule. If the “Protocol” filed is not been selected or is
selected as ICMP, the “Src Port” filed can’t be configured.
Dest Port:
The destination port number of the rule. If the “Protocol” filed is n
ot been selected or
is selected as ICMP, the “Dest Port” filed can’t be configured.
Protocol:
The protocol of the rule. It can be TCP, UDP, and ICMP.
Phy port:
The incoming port of the rule. It indicates the physical port of the traffic is incoming.
Set Priority:
The priority of the rule. It can be p0(highest), p1, p2, p3(lowest). The traffic
matches the rule will be assigned the priority you have configured.
Insert or modify QoS mark:
You can insert or modify the DSCP or 802.1p tag. The traffic
matches the rule will be added or modified the mark.
Note:
If you select 802.1p tag, please make sure 802.1q is enabled in specified WAN interface;
otherwise 802.1p tag will not be tagged.
Apply:
After filling the parameters, click this button to add a new rule.
QoS Rule List:
Shows the current rules on the device.
Delete:
Select a rule then press the
delete
button, the selected rule will be deleted from QoS
rule list.
Delete all:
Delete all the rules from QoS rule list.