TRENDnet TEG-240WS Router Manual PDF (Setup & Configuration Guide)

Given below is full router user manual of TRENDnet TEG-240WS router model. You can also download this manual in PDF Format to read later on your computer.

Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.

Page 1 / 10
TEG-160WS
TEG-240WS
C2
Quick Installation Guide
Page 2 / 10
Table of Contents
Version 02.02.2010
English
1
1. Before You Start
2. Hardware Installtion
2
3. Web Management Utility
3
1
Troubleshooting
6
Page 3 / 10
1. Before You Start
Package Contents
?
?
CD-ROM (Utility & User’s Guide)
?
Multi-Language Quick Installation Guide
?
2 Mounting Brackets with Screws
?
Power Cord
TEG-160WS/TEG-240WS
System Requirements
1
?
Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above)
?
Computer with Network adapter installed
?
Mini-GBIC module (e.g. TEG-MGBSX, TEG-MGBS10, TEG-MGBS40,
TEG-MGBS80, TEG-MGBS10D35, TEG-MGBS40D35) for Mini-GBIC slots
Page 4 / 10
2. Hardware Installation
2
Note
:
1.
After hardware installation is complete, use the Web Browser to configure the
TEG-160WS/TEG-240WS. To access the Web Browser configuration, open your web
browser, and enter the default IP Address http://192.168.0.1 and default password
"admin". Make sure your computer and the TEG-160WS/TEG-240WS are configured
to the same network segment.
2.
The Mini-GBIC slots are shared with Port 15 and 16 (TEG-160WS) and port 23 and
24 (TEG-240WS) Gigabit Ethernet ports.
When the Mini-GBIC slots are in use, port
15 and 16 (TEG-160WS) and port 23 and 24 (TEG-240WS) Gigabit Ethernet ports
are disabled.
2.
Connect a CAT-5e or 6 RJ-45 network cable
from the computer to an available Ethernet port
of the TEG-160WS/TEG-240WS.
1.
Connect the
Power Cord
to the rear of the
TEG-160WS/TEG-240WS
and then to a power
outlet.
Page 5 / 10
3
2.
Follow the
Installation Wizard
instructions.
Click
OK
.
1
. Insert the
Utility & User’s Guide CD-ROM
into
your computer's CD-ROM Drive and then click
Install Utility
.
3. Web Management Utility
Note
: If you would like to easily discover all the Web Management Switches on the
network, assign IP Address, change the password, and upgrade to new firmware, then
install the Web Management Utility. Follow the steps below.
For Windows User
3.
Click
Start
g
Programs
g
Web_Management_Utility
, and then click
Web_Management_Utility
.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top