Page 26 / 145
Scroll up to view Page 21 - 25
65xx-A1 Family Router Users Guide
26
xDSL Statistics
Display ADSL statistics by clicking
xDSL
under
Statistics
. Information contained in this screen is
useful for troubleshooting and diagnostics of connection problems.
ADSL BER Test
The ADSL Bit Error Rate (BER) test determines the quality of the ADSL connection. The test is
performed by transferring idle cells containing a known pattern and comparing the received data
with this known pattern to check for any errors The
BER Test
reflects the ratio of error bits to the
total number transmitted.
Page 27 / 145
65xx-A1 Family Router Users Guide
27
If you click on the
ADSL BER Test
button at the bottom of the ADSL Statistics page, the following
pop-up screen will appear allowing you to set the tested time and to begin the test.
To run a BER test:
1.
On the bottom of the
xDSL statistics
page, click
xDSL BER Test
2.
In the
Tested Time (sec)
drop down, select the test duration, and then click
Start
.
3.
Check the results.
Route
Access the routing status report from the router by clicking
Route
under
Device Info
.
Page 28 / 145
65xx-A1 Family Router Users Guide
28
ARP
Display the ARP status report by clicking
ARP
under
Device Info
.
ARP (Address Resolution Protocol) maps the IP address to the physical address, labelled
HW
Address
(the MAC address) and identifies computers on the LAN.
DHCP
Display the DHCP lease information by clicking
DHCP
under
Device Info
.
DHCP (Dynamic Host Control Protocol) allows the modem to automatically assign IP addresses,
to connected devices. By default, your modem is set up to assign devices addresses from
192.168.1.2 to 192.168.1.254.
Page 29 / 145
65xx-A1 Family Router Users Guide
29
19216811.live