Page 66 / 145
Scroll up to view Page 61 - 65
65xx-A1 Family Router Users Guide
66
7.
Click
Save/Apply
.
QoS Classification
You can configure the Quality of Service to apply different priorities to traffic on the router.
The
Add Network Traffic Class Rule
screen allows you to add a network traffic class rule.
Page 67 / 145
65xx-A1 Family Router Users Guide
67
To add a rule:
1.
In the
Quality of Service—QoS Classification
screen, click
Add
.
=
2.
In the
Add Network Traffic Class Rule
screen give a name to this traffic class.
3.
Specify a
Rule Order
and enable the rule in the
Rule Status
.
4.
Enter
Classification Criteria
:
•
Class Interface
: The interface to apply the rule on. Depending on the class of interface
options for the traffic rule will change.
•
Ether Type
: Type of Ethernet packet used on the interface. Depending on the Ether Type
selected, options for the traffic rule will change.
•
Source/Destination MAC Address
and
Source/Destination MAC Mask
. Source and
destination MAC address.
•
For UDP and TCP protocols, also enter
Source
and
Destination
ports.
5.
Enter
Classification Results
:
•
Assign Classification Queue
: The interface to apply the rule on. Depending on the
class of interface options for the traffic rule will change.
•
Mark DSCP
: Type of Ethernet packet used on the interface. Depending on the Ether
Page 68 / 145
65xx-A1 Family Router Users Guide
68
Type selected, options for the traffic rule will change.
•
Mark 802.1p Priority
. 802.1p priority.
•
Tag VLAN ID
:
VLAN ID.
6.
Click
Save / Apply
to save the settings.
Routing
Under the Routing heading you assign a default gateway, create a routing table (in Static Route),
create routing policy rules, and activate Routing Information Protocol (RIP) on the device.
Default Gateway
You can enable an automatic assigned default gateway on the
Routing – Default Gateway
screen or specify a static default gateway. By default, the router will use an available WAN
interface as the default gateway.
To enable
Automatic Assigned Default Gateway
leave the checkbox checked. To disable
Automatic Assigned Default Gateway
uncheck the checkbox.
Page 69 / 145
65xx-A1 Family Router Users Guide
69
If you change the automatic assigned default gateway address, you must reboot the router to be
assigned a new default gateway IP address.
Static Route
To add a routing table use the
Static Route
page. A maximum of 32 entries can be configured.
1.
Click
Add
.
Page 70 / 145
65xx-A1 Family Router Users Guide
70
2.
Enter the route information and then click
Apply/Save
.
Policy Route
The policy routing feature allows the administrator to have more control over how packets should
flow through the modem and into their networks. The feature allows administrator to route IP
packets according to their Source Interface; Source/Destination IP address/subnets; IP Protocols;
Source/Destination Ports to specific Gateway address and/or Gateway Interfaces.
19216811.live