030-300613 Rev A
121
August 2009
User Guide
VersaLink Wireless Gateway (Model 7500)
Selection box
Displays the devices available to share the Single Static IP address the ISP has
assigned the Gateway. The names listed in the select box will be populated by the
Gateway’s DHCP server based on DHCP requests. If a device’s name cannot be
determined, the current IP address of the device will be placed in the list.
•
When the feature is enabled, the active machine will be highlighted in the
select box and displayed at the bottom of the screen with the
Disable
button.
•
When the feature is disabled, no device in the select box will be
highlighted, and the
Enable
button will be available.
•
When
User Configured PC
is selected, a local PC must be configured
manually with the WAN IP address as its Ethernet adapter’s IP address.
To enable Single Static IP, select a device that will share your Single Static IP from the options listed in the
selection box, click
Enable
and then
OK
. Your Gateway will be reset, and the new configuration will take effect.
After a brief delay, the
Home
screen will appear. Confirm that you have a DSL sync and that your PPP session
displays UP.
(If necessary, click
connect
in the
Home > Connection Overview
screen to establish a PPP session.)
Select
Advanced > Single Static IP
to confirm that Single Static IP has been enabled, as shown in the following
screen.
IMPORTANT:
After you enable Single Static IP, reboot your computer to allow the changes to take effect.
NOTE:
If you chose to enable
User Configured PC,
wait for the Gateway to reset, and then manually type the
WAN IP, Gateway, and Subnet mask addresses you obtained from your ISP into a PC.
To disable Single Static IP, select a device that will share your Single Static IP from the options listed in the
window, click
Disable
and then
OK
. Your Gateway will be reset, and the new configuration will take effect.