Page 26 / 112 Scroll up to view Page 21 - 25
TL-WR940N
Wireless N Router
Figure 4-1
Router Status
4.3 Quick Setup
Please refer to
3.2 Quick Installation Guide
.
4.4 QSS
This section will guide you add a new wireless device to an existing network quickly by
QSS
(Quick Secure Setup)
function.
-18-
Page 27 / 112
TL-WR940N
Wireless N Router
a).
Choose menu “
QSS
”, you will see the next screen (shown in
Figure 4-2
).
Figure 4-2
QSS
¾
QSS Status -
Enable or disable the QSS function here.
¾
Current PIN -
The current value of the Router's PIN displayed here. The default PIN of the
Router can be found in the label or User Guide.
¾
Restore PIN -
Restore the PIN of the Router to its default.
¾
Gen New PIN -
Click this button, and then you can get a new random value for the Router's
PIN. You can ensure the network security by generating a new PIN.
¾
Add device -
You can add the new device to the existing network manually by clicking this
button.
b).
To add a new device:
If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can establish a wireless
connection between wireless adapter and Router using either Push Button Configuration (PBC)
method or PIN method.
)
Note:
To build a successful connection by QSS, you should also do the corresponding configuration of
the new device for QSS function meanwhile.
For the configuration of the new device, here takes the Wireless Adapter of our company for
example.
I.
By PBC
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration (PBC)
method, you can add it to the network by PBC with the following two methods.
Method One:
Step 1:
Press the QSS button on the front panel of the Router.
Step 2:
Press and hold the QSS button of the adapter directly for 2 or 3 seconds.
-19-
Page 28 / 112
TL-WR940N
Wireless N Router
Step 3: Wait for a while until the next screen appears. Click
Finish
to complete the QSS
configuration.
The QSS Configuration Screen of Wireless Adapter
Method Two:
Step 1: Press the QSS button on the front panel of the Router.
Step 2: For the configuration of the wireless adapter, please choose
Push the button on my
access point
in the
configuration utility of the QSS as below, and click
Next
.
-20-
Page 29 / 112
TL-WR940N
Wireless N Router
The QSS Configuration Screen of Wireless Adapter
Step 3: Wait for a while until the next screen appears. Click
Finish
to complete the QSS
configuration.
The QSS Configuration Screen of Wireless Adapter
Method Three:
Step 1:
Keep the default QSS Status as
Enabled
and click the
Add device
button in
Figure 4-2
,
then the following screen will appear.
-21-
Page 30 / 112
TL-WR940N
Wireless N Router
Figure 4-3
Add A New Device
Step 2:
Choose
Press the button of the new device in two minutes
and click
Connect
.
Step 3:
For the configuration of the wireless adapter, please choose
Push the button on my
access point
in the
configuration utility of the QSS as below, and click
Next
.
The QSS Configuration Screen of Wireless Adapter
Step 4:
Wait for a while until the next screen appears. Click
Finish
to complete the QSS
configuration.
-22-

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top