Page 121 / 128
Scroll up to view Page 116 - 120
TL-WR2543ND
450Mbps Dual-Band Wireless N Gigabit Router
- 114 -
F
igure A-8
Remote Management
)
Note:
If the above configuration takes effect, you can visit and configure the Router by typing
(the Router’s LAN IP address: Web Management Port) in the address
field of the Web browser. If the LAN IP of the modem connected with your router is
192.168.0.x, the default LAN IP of the Router will automatically switch from
192.168.0.1 to
192.168.1.1 to avoid IP conflict; in this case, please try
.
3)
Log in to the Router, click the “
Forwarding
” menu on the left of your browser, and click
the "
Virtual Servers
" submenu. On the "
Virtual Servers
" page, click
Add New…
, then
on the “
Add or Modify a Virtual Server
” page, enter “80” into the blank next to the
“
Service Port
”, and your IP address next to the “
IP Address
for an example, remember to
Enable
and
Save
.
Figure A-9
Virtual Servers
Page 122 / 128
TL-WR2543ND
450Mbps Dual-Band Wireless N Gigabit Router
- 115 -
Figure A-10
Add or Modify a Virtual server Entry
5.
The wireless stations cannot connect to the Router.
1)
Make sure the "
Wireless Router Radio
" is enabled.
2)
Make sure that the wireless stations' SSID accord with the Router's SSID.
3)
Make sure the wireless stations have right KEY for encryption when the Router is
encrypted.
4)
If the wireless connection is ready, but you can’t access the Router, check the IP Address
of your wireless stations.
Page 123 / 128
TL-WR2543ND
450Mbps Dual-Band Wireless N Gigabit Router
- 116 -
Appendix B: Configuring the PCs
In this section, we’ll introduce how to install and configure the TCP/IP correctly in Windows XP.
First make sure your Ethernet Adapter is working, refer to the adapter’s manual if needed.
1.
Install TCP/IP component
1)
On the Windows taskbar, click the
Start
button, point to
Settings
, and then click
Control
Panel
.
2)
Click the
Network and Internet Connections
icon, and then click on the
Network
Connections
tab in the appearing window.
3)
Right click the icon that showed below, select Properties on the prompt page.
Figure B-1
Page 124 / 128
TL-WR2543ND
450Mbps Dual-Band Wireless N Gigabit Router
- 117 -
4)
In the prompt page that showed below, double click on the
Internet Protocol (TCP/IP)
.
Figure B-2
5)
The following
TCP/IP Properties
window will display and the
IP Address
tab is open on
this window by default.
Page 125 / 128
TL-WR2543ND
450Mbps Dual-Band Wireless N Gigabit Router
- 118 -
6)
Select
Obtain an IP address automatically
and
Obtain DNS server automatically
, as
shown in the Figure below:
Figure B-3
19216811.live