Page 21 / 77
Scroll up to view Page 16 - 20
TD-8840T
ADSL2+ Modem Router User Guide
15
Chapter 4. Configuring the Modem Router
This chapter will show each Web page's key function and the configuration way.
4.1 Login
After your successful login, you will see the fifteen main menus on the left of the Web-based utility.
On the right, there are the corresponding explanations and instructions.
The detailed explanations for each Web page’s key function are listed below.
4.2 Status
Choose “
Status
”, you can see the corresponding information about
Device Information
,
DSL
,
WAN
and
LAN
.
Page 22 / 77
TD-8840T
ADSL2+ Modem Router User Guide
16
Figure 4-1
4.3 Quick Setup
Please refer to Section
3.2 Login
.
4.4 Network
Choose “
Network
”, there are many submenus under the main menu. Click any one of them, and
you will be able to configure the corresponding function.
Page 23 / 77
TD-8840T
ADSL2+ Modem Router User Guide
17
4.4.1 WAN Settings
Choose “
Network
”
Æ
“
WAN Settings
”, and you will see the WAN Port Information Table in the
screen similar to Figure 4-2, which describes the WAN port settings and the relevant manipulation
to each interface. There are five different configurations for the connection types, which are Static
IP, Dynamic IP, PPPoE, IPoA, and Bridge. You can select the corresponding types according to
your needs.
Figure 4-2
Click
Add
to add a new entry, you can configure the parameters for ATM and WAN Service in the
next screen (shown in Figure 4-3).
Page 24 / 77
TD-8840T
ADSL2+ Modem Router User Guide
18
Figure 4-3
4.4.1.1 Static IP
Select this option if your ISP provides static IP information to you. You should set static IP address,
IP subnet mask, and gateway address in the screen below.
Page 25 / 77
TD-8840T
ADSL2+ Modem Router User Guide
19
Figure 4-4
ATM Configuration:
¾
VPI (0~255):
Identifies the virtual path between endpoints in an ATM network. The valid range
is from 0 to 255. Please input the value provided by your ISP.
¾
VCI (1~65535):
Identifies the virtual channel endpoints in an ATM network. The valid range is
from 1 to 65535 (1 to 31 is reserved for well-known protocols). Please input the value
provided by your ISP.
Click
Advanced
, advanced selections of ATM Configuration can be shown.
¾
Encapsulation Mode:
Select the encapsulation mode for the Static IP Address. Here you
can leave it default.
¾
ATM Qos Type:
Select ATM Qos Type provided by ISP, and the type is UBR by default.
WAN Service Setup:
¾
IP Address:
Enter the IP address in dotted-decimal notation provided by your ISP.
¾
Subnet Mask:
Enter the subnet Mask in dotted-decimal notation provided by your ISP,
usually is 255.255.255.0.
¾
Default Gateway
(Optional): Enter the gateway IP address in dotted-decimal notation
provided by your ISP.
¾
DNS Server/ Secondary DNS Server:
Here you can set DNS Server (at least one) manually.
The Route will use this DNS Server for priority.
19216811.live