Page 26 / 114
Scroll up to view Page 21 - 25
22
Chapter 4
Set Up Internet Connections
5. Click
Save
to make the settings take effect. To check your Internet connection, click
Network Map
on the left of the page.
Note:
It may take 1-2 minutes to make the settings valid.
6. After the connection succeed, the screen will display as follows. Here we take PPPoE
as an example.
Tips:
1. If your Internet connection type is
Bigpond Cable
, please go to
Advanced
>
Network
>
Internet
.
2. If you use
Dynamic IP
and
PPPoE
and you are provided any other parameters that are not required on the page,
please go to
Advanced
>
Network
>
Internet
to complete the configuration.
Page 27 / 114
23
Chapter 4
Set Up Internet Connections
3. If you still cannot connect to the Internet, refer to
FAQ
for further instructions.
4. 3.
Setting Up an IPv6 Internet Connection
Your ISP provides information about one of the following Internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel,
Pass-Through (Bridge).
1. Visit
http://tplinkwifi.net
, then log in with the password you set for the router.
2. Go to
Advanced
>
IPv6
to log into the configuration page.
3. Select the Internet connection type provided by ISP.
Tips:
If you do not know what your Internet connection type is, contact your ISP or judge according to already known
information provided by your ISP.
4. Fill in information as required by different connection type. (Red blanks must be
filled.)
1 )
Static IP:
Fill in blanks and click
Save
.
Page 28 / 114
24
Chapter 4
Set Up Internet Connections
2 )
Dynamic IP(SLAAC/DHCPv6):
Click
Advanced
to have more configuration if
ISP requires. Click
Save
to save the settings and then click
Renew
to finish the
configuration.
3 )
PPPoE:
Fill in the Username and Password. Click
Advanced
to have more
configuration if ISP requires. Click
Save
to save the settings and then click
Connect
to finish the configuration.
Page 29 / 114
25
Chapter 4
Set Up Internet Connections
4 )
6to4 Tunnel:
An IPv4 Internet connection type is a prerequisite for this
connection type. (
4. 2
) Click
Advanced
to have more configuration if ISP
requires. Click
Save
to save the settings and then click
Connect
to finish the
configuration.
5 )
Pass-Through (Bridge):
Click
Save
and skip to step 6.
Page 30 / 114
26
Chapter 4
Set Up Internet Connections
5. Configure LAN ports. Windows users are recommended to choose from the first two
types. Fill in Address Prefix provided by ISP, and click
Save
to save the settings.
Tips:
Find
Help
on the management interface to know more about items.
6. Click
Status
to check whether you succeed or not. The following figure is an example
of a successful PPPoE configuration.
Tips:
Visit
FAQ
if there is no Internet connection.
19216811.live