Page 56 / 76
Scroll up to view Page 51 - 55
11N Wireless Broadband Router
51
10.3 MAC Address Filter
In order to manage the computers in LAN better, you
could control the computer’s access to Internet by MAC
Address Filter.
¾
MAC Address Filter:
Check to enable MAC
address filter.
¾
Access Policy:
Select one number from the
drop-down menu.
¾
Enable:
Check to enable the access policy.
¾
Clear the Policy:
Click “Clear” button to clear all
settings for the policy.
¾
Filter Mode:
Click one radio button to enable or
disable to access the Internet.
¾
Policy Name:
Enter a name for the access policy
selected.
Page 57 / 76
11N Wireless Broadband Router
52
¾
MAC Address:
Enter the MAC address you want to
run the access policy.
¾
Times:
Select the time range of client filter.
¾
Date:
Select the day(s) to run the access policy.
¾
Apply:
Click to make the settings go into effect.
For example:
If you want to configure the host with MAC address
00:C0:9F:AD:FF:C5 not to access the Internet at
8:00-18:00, you need to set it as above.
10.4 Prevent Network Attack
This section is to protect the internal network from
exotic attack such as SYN Flooding attack, Smurf attack,
LAND attack, etc. Once detecting the unknown attack,
the Router will restrict its bandwidth automatically.
The attacker’s IP address can be found from the
“System Log”.
¾
Prevent Network Attack:
Check to enable it for
attack prevention.
Page 58 / 76
11N Wireless Broadband Router
53
10.5 Remote Web Management
This section is to allow the network administrator to
manage the Router remotely. If you want to access the
Router from outside the local network, please select the
“Enable”.
¾
Enable:
Check
to
enable
remote
web
management.
¾
Port:
The management port open to outside
access. The default value is 80.
¾
WAN IP Address:
Specify the range of the WAN IP
address for remote management.
Note:
1. If you want to login the device’s Web-based
interface via port 8080, you need use the format of
WAN IP address: port (for example
remote login.
Page 59 / 76
11N Wireless Broadband Router
54
2. If your WAN IP address starts and ends with
0.0.0.0, it means all hosts in WAN can implement
remote Web management. If you change the WAN
IP address as 218.88.93.33-218.88.93.35, then
only the IP addresses as 218.88.93.33,
218.88.93.34 and 218.88.93.35 can access the
Router.
For example:
If you want to configure the IP address 218.88.93.33 to
access the device’s web interface, please set it as
above.
10.6 WAN Ping
The ping test is to check the status of your internet
connection. When disabling the test, the system will
ignore the ping test from WAN.
¾
Ignore Ping from WAN:
Check to ignore the ping request and give no reply.
Page 60 / 76
11N Wireless Broadband Router
55
Chapter 11 Routing Settings
11.1 Routing Table
The main duty for a router is to look for a best path for
every data frame, and transfer this data frame to a
destination. So, it’s essential for the router to choose
the best path, i.e. routing arithmetic. In order to finish
this function, many transferring paths, i.e. routing table,
are saved in the router, for choosing when needed.
19216811.live