Page 86 / 90
Scroll up to view Page 81 - 85
- 85 -
3.7.5
Time Zone
Choose
Admin
>
Time Zone
, the page shown in the following figure appears. You
can configure the system time manually or get the system time from the time
server.
Page 87 / 90
- 86 -
The following table describes the parameters of this page:
Field
Description
System Time
Set the system time manually.
NTP Configuration
State
Select enable or disable NTP function. You need
to enable NTP if you want to configure the
parameters of NTP.
Primary Server
Set the primary NTP server manually.
Secondary Server
Set the secondary NTP server manually.
Time Zone
Choose the time zone in which area you are from
the drop down list.
3.8
Diagnostic
In the navigation bar, click
Diagnostic
. The
Diagnostic
page that is displayed
contains
Ping
,
ATM Loopback
,
ADSL
and
Diagnostic Test
.
3.8.1
Ping
Choose
Diagnostic
>
Ping
. The page shown in the following figure appears.
The following table describes the parameter and button of this page:
Field
Description
Host
Enter the valid IP address or domain name.
Run Ping
Click it to start to Ping.
Page 88 / 90
- 87 -
3.8.2
ATM Loopback
Choose
Diagnostic
>
ATM Loopback
. The page shown in the following figure
appears. In this page, you can use VCC loopback function to check the
connectivity of the VCC. The ATM loopback test is useful for troubleshooting
problems with the DSLAM and ATM network.
Click
Run Loopback
to start testing.
3.8.3
ADSL
Choose
Diagnostic
>
ADSL
. The page shown in the following figure appears. It is
used for ADSL tone diagnostics.
Page 89 / 90
- 88 -
Click
Start
to start ADSL tone diagnostics.
3.8.4
Diagnostic Test
Choose
Diagnostic
>
Diagnostic Test
, the page shown in the following figure
appears. In this page, you can test the DSL connection. You can also view the LAN
status connection and ADSL connection.
Click
Run Diagnostic Test
to start testing.
19216811.live