Set Time Zone
: Select the time zone of the country you are currently in. The
router will set its time based on your selection.
Time Server Address:
You can set an NTP server address.
Enable Daylight Savings
: The router can also take Daylight savings into
account. If you wish to use this function, you must check/tick the enable boxto
enable your daylight saving configuration (below).
Start Daylight Savings Time
: Select the period in which you wish to start
daylight Savings Time.
End Daylight Savings Time
: Select the period in which you wish to end daylight
Savings Time.
Click
Apply
at the bottom of the screen to save the above configuration.
Remote Management
The remote management function allows you to designate a host in the Internet the
ability to configure the Broadband router from a remote site. Enter the designated host
IP Address in the Host IP Address field.
Host Address
: This is the IP address of the host in the Internet that will have
management/configuration access to the Broadband router from a remote site. If
the Host Address is left 0.0.0.0 this means anyone can access the router’s web
-
based configuration from a remote location, providing they know the password.
Port
: The port number of the remote management web interface.
Enabled
:
Select “Enabled” to enable
the remote management function.
19216811.live