Page 61 / 74
Scroll up to view Page 56 - 60
Inbound Filter
When you use the Virtual Server, Port Forwarding, or Remote Administration
features to open specific ports to traffic from the Internet, you could be
increasing the exposure of your LAN to cyber attacks from the Internet. In these
cases, you can use Inbound Filters to limit that exposure by specifying the IP
addresses of internet hosts that you trust to access your LAN through the ports
that you have opened.
Inbound Filters can be used for limiting access to a server on your network to a
system or group of systems. Filter rules can be used with Virtual Server, Gaming,
or Remote Administration features.
°
Name
Specify a name for the inbound filter.
°
Action:
Select Allow or Deny from the drop-down list. This will apply the
inbound filter rule on the WAN interface.
°
Remote IP Range:
Specify the remote IP address range and then click in the
check box to enable the range.
Click on the
Save
button to store the changes.
Page 62 / 74
Bandwidth
Using this page, it’s possible to perform a variety of network tests between the
router and other LAN devices.
Choose the
Test Type,
select a computer (or enter it’s MAC address), and click
the
Start
-button to start bandwidth testing.
Page 63 / 74
Disk
This page shows information regarding the attached storage devices. File system
type, total space on the device, and available space is shown in the table.
Click the “
Safely remove
” button, to safely remove the USB disk.
Note:
Only FAT12, FAT16, and FAT32 drives are supported. For information
regarding partitioning and formatting of a drive, see the manual of
your operating system.
Page 64 / 74
Share
On this page, the sharing mode can be changed. Choose to share all folders with
all users, or to restrict the sharing of folders. When Sharing-mode is set to
“restrict”, shares can be added and changed.
Page 65 / 74
Users
You can add new users and configure user rights for the storage device.
°
Password
: Enter a password for the selected user.
°
Share Name
: Select a shared folder. The Shared folders can be configured
on the “Share” tab.
°
Access
: Select “Read Only” to allow the user to read files in the selected
share. Select “Read/Write” to also allow users to write to the selected share.
19216811.live