Page 6 / 68
Scroll up to view Page 1 - 5
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
5
-
Firewall
o
IP/Port filtering
o
MAC filtering
-
ATM
o
ITU-T 1.610 F4/F5 OAM send and receiver loop-back
o
ATM QoS : CBR, rt-VBR, nrt-VBR and UBR
o
Multiple PVC : support 8 PVCs
2.2.4
Management
-
Web-based configuration
-
Telnet remote management
-
SNMP v1/v2/Trap
-
Diagnostic tool
-
Firmware upgrade through FTP, TFTP and HTTP
-
UPnP support
-
ACL (Access Control List)
Page 8 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
7
3.3
Hardware Setup Procedures
3.3.1
Connect RJ-11 line from Hurricane 5004N to the wall phone socket
3.3.2
Connect RJ-45 line from your PC LAN Port to Hurricane 5004N Ethernet port
3.3.3
Connect the 1
0
V power adapter
Page 9 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
8
Chapter 4
Software Configuration
The DSL device is an ADSL2+ wireless router. When you power on the device, the system will boot up
and connect to ADSL automatically. The system provides a PVC for bridge test by default. The default
configurations for the system are listed below.
z
LAN IP address:
192.168.1.1
, Netmask:
255.255.255.0
z
UART setting: 115200bps, 8 bits, no parity, 1 stop bit, no flow control.
z
VPI/VCI for ATM:
0/35
z
ADSL Line mode: Auto-detect.
User can change settings via WEB browser. The following sections describe the set up procedures.
Please set your PC’s Ethernet port as follow:
z
IP address:
192.168.1.XXX
z
Netmask:
255.255.255.0
Access the Web Console:
z
Start your web browser.
z
Type the Ethernet IP address of the modem/router on the address bar of the browser. Default
z
The Enter Network Password dialog box appears. Default Username:
admin
Password:
password
Page 10 / 68
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
9
Once you have connected to ADSL2+ router. You will see the status page.
This page displays the ADSL modem/router’s current status and settings. This information is read-only
except for the PPPoE/PPPoA channel for which user can connect/disconnect the channel on demand.
Click the “Refresh” button to update the status
Function buttons in this page:
Connect
/
Disonnect
The two buttons take effect only when PVC is configured as PPPoE/PPPoA mode. Click
Connect/Disconnect button to connect/disconnect the PPP dial up link.
19216811.live