Page 26 / 35 Scroll up to view Page 21 - 25
DISCUS™ DRG A225G
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
28
SAFETY INFORMATION
This section contains directions that you must follow for your personal safety.
Follow all directions carefully. You must read the following safety information
carefully before you install or remove the unit.
- Use only the power adapter that is supplied with the unit. The use of an alternative
adapter can damage the Router and invalidate the warranty.
- Use an electrical outlet within easy distance and do not damage the power cable.
- To avoid electrical shock, do not open the Router.
- To prevent fire or shock hazard, do not expose your Router to rain or moisture,
liquid and toxic substances.
- Particular care must be taken during installation and removal of cables and tele-
phone line.
- Never touch uninsulated telephone wire or terminals unless the telephone line has
been disconnected at the network interface.
- Ensure the correct ventilation to the Router. Do not obstruct the air conducts and
do not lean anything over.
- Verify to place the Router out of direct sunlight and away from sources of heat.
- Avoid using your Router during an electrical storm.
- The Router generates and uses Radio Frequency (RF) energy. In some environ-
ments, the use of RF energy is not permitted. The user should seek local advice on
whether or not RF energy is permitted within the area of intended use.
Downloaded from
www.Manualslib.com
manuals search engine
Page 27 / 35
DISCUS™ DRG A225G
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
29
CERTIFICATIONS
CE Mark
We, Pirelli BroadBand Solutions SpA, Viale Sarca, 222 - 20126 Milano -
www.Pirelli.com – Italy declare under our own responsibility that the product
DISCUS™ DRG A225G
(P/N 151070501) to which this declaration refers con-
forms with the relevant standards according to the regulation in Article 3.1.a,
3.1.b and 3.2 of the R&TTE Directive 1999/5/EEC of the European Community
Standards Applied:
- EN 55022
- EN 61000-3-2
- EN 61000-3-3
- EN 301 489-1
- EN 301 489-17
- EN 300 328
- EN 60950-1
National Authorities were informed according to Article 6.4 of Frequency Notifi-
cation.
Special Requirements are considered. The product is labeled with CE Marking.
Any unauthorized modification of the product voids this declaration.
Downloaded from
www.Manualslib.com
manuals search engine
Page 28 / 35
DISCUS™ DRG A225G
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
30
WEEE
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)
DIRECTIVE 2002/96/EC
This product complies with the WEEE Directive (2002/96/EC) marking require-
ment. The affixed product label (see above) indicates that you must not discard
this electrical/electronic product in domestic household waste.
Product category: With reference to the equipment types in the WEEE directive
Annex 1, this product is classified as an “IT and telecommunications equipment”
product.
Do not dispose in domestic household waste.
Downloaded from
www.Manualslib.com
manuals search engine
Page 29 / 35
DISCUS™ DRG A225G
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
31
GLOSSARY
802.11b
The IEEE specification for wireless Ethernet which allows speeds of up to 11
Mbps. The standard provides for 1, 2, 5.5 and 11 Mbps data rates. The rates
will switch automatically depending on range and environment.
802.11g
The IEEE specification for wireless Ethernet which allows speeds of up to 54
Mbps. The standard provides for 6, 12, 24, 36, 48 and 54 Mbps data rates. The
rates will switch automatically depending on range and environment.
10BASE-T
The IEEE specification for 10 Mbps Ethernet over Category 3, 4 or 5 twisted
pair cable.
100BASE-TX
The IEEE specification for 100 Mbps Fast Ethernet over Category 5 twisted-pair
cable.
Access Point
An Access Point is a device through which wireless clients connect to other
wireless clients and which acts as a bridge between wireless clients and a wired
network, such as Ethernet. Wireless clients can be moved anywhere within the
coverage area of the access point and still connect with each other. If con-
nected to an Ethernet network, the access point monitors Ethernet traffic and
forwards appropriate Ethernet messages to the wireless network, while also
monitoring wireless client radio traffic and forwarding wireless client messages
to the Ethernet LAN.
Channel
Similar to any radio device, the Wireless Cable/DSL router allows you to choose
different radio channels in the wireless spectrum. A channel is a particular fre-
quency within the 2.4GHz spectrum within which the Router operates.
Downloaded from
www.Manualslib.com
manuals search engine
Page 30 / 35
DISCUS™ DRG A225G
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
32
DHCP
Dynamic Host Configuration Protocol. This protocol automatically assigns an IP
address for every computer on your network. Windows 95, Windows 98 and
Windows NT 4.0 contain software that assigns IP addresses to workstations on
a network. These assignments are made by the DHCP server software that
runs on Windows NT Server, and Windows 95 and Windows 98 will call the
server to obtain the address. Windows 98 will allocate itself an address if no
DHCP server can be found.
DNS Server Address
DNS stands for Domain Name System, which allows Internet host computers to
have a domain name (such as pirelli.com) and one or more IP addresses (such
as 192.168.10.8). A DNS server keeps a database of host computers and their
respective domain names and IP addresses, so that when a domain name is
requested (as in typing “pirelli.com” into your Internet browser), the user is sent
to the proper IP address. The DNS server address used by the computers on
your home network is the location of the DNS server your ISP has assigned.
DSL
Short for digital subscriber line, but is commonly used in reference to the
asymmetric version of this technology (ADSL) that allows data to be sent over
existing copper telephone lines at data rates of from 1.5 to 9 Mbps when receiv-
ing data (known as the downstream rate) and from 16 to 640 Kbps when send-
ing data (known as the upstream rate). ADSL requires a special ADSL modem.
ADSL is growing in popularity as more areas around the world gain access.
DSL modem
DSL stands for digital subscriber line. A DSL modem uses your existing phone
lines to send and receive data at high speeds.
Encryption
A method for providing a level of security to wireless data transmissions. The
Router uses two levels of encryption; 40/64 bit and 128 bit. 128 bit is a more
powerful level of encryption than 40/64 bit.
Ethernet
A LAN specification developed jointly by Xerox, Intel and Digital Equipment
Corporation. Ethernet networks use CSMA/CD to transmit packets at a rate of
10 Mbps over a variety of cables.
Firewall
Electronic protection that prevents anyone outside of your network from seeing
your files or damaging your computers.
Downloaded from
www.Manualslib.com
manuals search engine

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top