Page 231 / 234 Scroll up to view Page 226 - 230
USER MANUAL
Peplink Balance Series
-231 / 234 -
Copyright © 2014 Peplink
Temperature: 0°C - 40°C
Humidity: 10% - 90% (non-condensing)
Page 232 / 234
USER MANUAL
Peplink Balance Series
-232 / 234 -
Copyright © 2014 Peplink
E.10 Peplink MediaFast 200/500
WAN Support
DHCP, PPPoE, and Static IP
Inbound and Outbound Link Load Balance
Device Management
Wizard & Menu Driven Web Management Interface over HTTP / HTTPS
Remote Reporting and Management
Bandwidth Usage Monitor
Configurations Upload and Download
Internet Access Sharing
SUA (Single User Account) / Multi-to-Multi NAT
NAT supports PAT (Port Address Translation)
Security
PPTP VPN Server
IPsec (Network-to-Network)
Rules-based Stateful Firewall, with IP, Protocol, and Port filtering
Bandwidth Bonding SpeedFusion
TM
VPN Encryption: 256-bit AES
Intrusion Detection System
Physical Interface
Five RJ-45 for an IEEE 802.3ab 10/100/1000M WAN
1
Three RJ-45 for an IEEE 802.3ab 10/100/1000M LAN /Two SFP+ for an IEEE 802.3ae 10G LAN
One RJ-45 Console / Serial Port
One USB for 3G/4G LTE Cellular Modem Connection
Power Specification
AC input 100-240V
Operating Environment
Temperature: 0°C - 40°C
Humidity: 10% - 90% (non-condensing)
1
MediaFast 500-B WAN ports 1-5 are active by default. Load balancing and/or a SpeedFusion license is required to activate MediaFast 500-A
WAN ports 2-5
Page 233 / 234
USER MANUAL
Peplink Balance Series
-233 / 234 -
Copyr
Appendix F. Declaration
1. CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
2.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
3.
Radiation Exposure Statement (for Balance One):
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC
regulation, all WiFi product marketed in US must fixed to US operation channels only.
Page 234 / 234
Contact Address:
United States Office
800 West El Camino Real,
Mountain View
CA 94040
United States
Tel:
+1 (650) 450 9668
Fax:
+1 (866) 625 4664
Hong Kong Office
A5, 5/F, HK Spinners
Industrial Building, Phase 6,
481 Castle Peak Road,
Cheung Sha Wan, Hong
Kong
Tel:
+852 2990 7600
Fax:
+852 3007 0588
Italy Office
Via Sismondi 50/3
20133 Milan
Italy
Tel:
+39 02 8986 6852
Saudi Arabia Office
3/F, Saudi Business Center,
Jeddah,
Saudi Arabia
Tel:
+39 02 8986 6852
Contact Us:
Sales
Support
Certified Peplink Partner
el-partner-program/
Difficulties when configuring the device?
Visit our
YouTube Channel
!
Want to know more about us?
Add us on
Facebook
!
What are we doing at the moment?
Follow us on
Twitter
!
http://twitter.com/Peplink
Anything want to share with everyone?
Discuss on
Peplink Forum
!
South Africa Office
Unit 24, Cambridge Office
Park,5 Bauhinia Street,
Highveld, Centurion,
South Africa
Tel:
+27 12 665 5829

Rate

3.5 / 5 based on 2 votes.

Popular Peplink Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top