Page 31 / 58
Scroll up to view Page 26 - 30
System> Password
The password entered is encrypted on the screen and will display as a sequence of asterisks (*).
The default password is ‘password’ and can be
changed here.
o
Type the old password in the Old Password field
o
Type the new password in the New Password field
o
Re-type the new password in the Re-type New Password field
o
Click Apply to activate the new password
Note
: The password is case sensitive and with a maximum length of 20.
Figure 5-10. System> Password> Password Setting
Page 31 of 58
Downloaded from
www.Manualslib.com
manuals search engine
Page 32 / 58
Switch
There are 4 options available:
o
Port Configuration
o
Statistics
o
VLAN
o
Trunking
Switch> Port Configuration
Switch> Port Configuration: Port Setting menu
You can configure the status per port by clicking a port ID in the port setting menu.
o
ID:
The port number on the switch.
Click this number to configure the port.
o
Speed:
Indicates the communication mode set for the port. The default setting for all ports is Auto-negotiation (Auto).
The possible entries are Auto-negotiation (Auto), 10 Mbps half duplex (10M Half), 10 Mbps full duplex (10M Full),
100 Mbps half duplex (100M Half), 100 Mbps full duplex (100M Full), or Disable.
o
Flow Control:
Indicates whether Flow Control support is set for on (Enabled) or off (Disabled). The default setting for all ports is
enabled.
o
QOS:
Indicate the priority for the port. The default setting for all ports is Normal.
Quality of Service (QoS) is a way of managing traffic in a network, by treating different types of traffic with different
levels of service priority.
Higher priority traffic gets faster treatment during times of switch congestion.
o
Link Status:
Indicates the current speed and duplex for the port. DOWN means no link.
Figure 5-11. Switch> Port Configuration> Port Setting menu
Page 32 of 58
Downloaded from
www.Manualslib.com
manuals search engine
Page 33 / 58
Switch> Port Configuration: Set speed
o
Click a port ID as shown in Figure 5-11
o
Click to select a speed from the pull-down menu under Speed
o
Click Apply to activate the new speed
Note
: Please be aware that speed must set as same as link partner. Otherwise, packet loss or link error might occur.
Figure 5-12. Switch> Port Configuration> Port Settings: Speed
Page 33 of 58
Downloaded from
www.Manualslib.com
manuals search engine
Page 34 / 58
Switch> Port Configuration: Set flow control
o
Click a port ID as shown in Figure 5-11
o
Click to select Enable or Disable from the pull-down menu under Flow Control
o
Click Apply to activate the new setting
Figure 5-13. Switch> Port Configuration> Port Settings: Flow Control
Page 34 of 58
Downloaded from
www.Manualslib.com
manuals search engine
Page 35 / 58
Switch> Port Configuration: Set QOS
o
Click a port ID as shown in Figure 5-11
o
Click to select Normal or High from the pull-down menu under QOS
o
Click Apply to activate the new setting
Figure 5-14. Switch> Port Configuration> Port Settings: QOS
Page 35 of 58
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live