1. Home
    2. /
  2. Manuals
    3. /
  3. NETGEAR
    4. /
  4. DGN2200v3
    5. /
  5. 32
Page 156 / 167 Scroll up to view Page 151 - 155
156
|
Appendix B.
NETGEAR VPN Configuration
N300 Wireless ADSL2+ Modem Router DGN2200
To check the VPN connection, you can initiate a request from the remote PC to the VPN
router’s network by using the Connect option in the modem router screen:
Right-click the system
tray icon to open the
pop-up menu.
Since the remote PC has a dynamically assigned WAN IP address, it has to initiate the
request.
a.
Right-click the system tray icon to open the pop-up menu.
b.
Select Connect to open the My Connections list.
c.
Select toDGN2200.
The modem router reports the results of the attempt to connect. Once the connection is
established, you can access resources of the network connected to the VPN router.
Right-click the system
tray icon to open the
pop-up menu.
To perform a ping test using this example, start from the remote PC:
a.
Establish an Internet connection from the PC.
b.
On the Windows taskbar, click the
Start
button, and then select
Run
.
c.
Type
ping -t 192.168.0.1
, and then click
OK
.
Page 157 / 167
Appendix B.
NETGEAR VPN Configuration
|
157
N300 Wireless ADSL2+ Modem Router DGN2200
This causes a continuous ping to be sent to the VPN router. Within 2 minutes, the ping
response should change from
timed out
to
reply
.
Once the connection is established, you can open the browser on the PC and enter the LAN
IP address of the VPN router. After a short wait, you should see the login screen of the VPN
router (unless another PC already has the VPN router management interface open).
Note:
You can use the VPN router diagnostics to test the VPN connection
from the VPN router to the client PC. To do this, select Diagnostics
on the modem router main menu.
Monitoring the VPN Tunnel (Telecommuter Example)
To view information about the progress and status of the VPN client connection, open the Log
Viewer. In Windows, click
Start
, and select Programs > N300 Wireless ADSL2+ Modem
Router DGN2200 > Log Viewer.
Note:
Use the active VPN tunnel information and pings to determine
whether a failed connection is due to the VPN tunnel or some
reason outside the VPN tunnel.
The Connection Monitor screen displays:
Page 158 / 167
158
|
Appendix B.
NETGEAR VPN Configuration
N300 Wireless ADSL2+ Modem Router DGN2200
While the connection is being established, the connection name listed in this screen shows
SA before the name of the connection. When the connection is successful, the SA changes
to the yellow key symbol.
Note:
While your PC is connected to a remote LAN through a VPN, you
might not have normal Internet access. If this is the case, you need
to close the VPN connection to have normal Internet access.
Viewing the VPN Router’s VPN Status and Log Information
To view information about the status of the VPN client connection, open the VPN router’s
VPN Status screen:
1.
On the modem router main menu, select Router Status, and then click the
VPN Status
button. The VPN Status/Log screen displays:
2.
To view the VPN tunnels status, click
VPN Status
.
Page 159 / 167
Appendix C.
Notification of Compliance
|
159
C
C.
Notification of Compliance
Wireless Routers, Gateways, and Access Points
Regulatory Compliance Information
This section includes user requirements for operating this product in accordance with National laws for usage of radio
spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may
result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.
Note: This product’s firmware limits operation to only the channels allowed in a particular Region or Country.
Therefore, all options described in this user's guide may not be available in your version of the product.
FCC Requirements for Operation in the United States
FCC Information to User
This product does not contain any user serviceable components and is to be used with approved antennas only.
Any product changes or modifications will invalidate all applicable regulatory certifications and approvals
FCC Guidelines for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC Declaration of Conformity
We, NETGEAR, Inc., 350 East Plumeria Drive, Santa Clara, CA 95134, declare under our sole responsibility that
the model N300 Wireless ADSL2+ Modem Router DGN2200 complies with Part 15 Subpart B of FCC CFR47
Rules. Operation is subject to the following two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following methods:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Page 160 / 167
160
|
Appendix C.
Notification of Compliance
N300 Wireless ADSL2+ Modem Router DGN2200
FCC Caution
•
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
•
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
•
For product available in the USA market, only channel 1~11 can be operated. Selection of other channels is not
possible.
•
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or
transmitter.
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (N300 Wireless ADSL2+ Modem Router DGN2200) does not exceed the Class B limits for
radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Interference Reduction Table
Table 14.
Household Appliance
Recommended Minimum Distance between
NETGEAR equipment and household appliance to
reduce interference (in feet and meters)
Microwave ovens
30 feet / 9 meters
Baby Monitor - Analog
20 feet / 6 meters
Baby Monitor - Digital
40 feet / 12 meters
Cordless phone - Analog
20 feet / 6 meters
Cordless phone - Digital
30 feet / 9 meters
Bluetooth devices
20 feet / 6 meters
ZigBee
20 feet / 6 meters
Europe – EU Declaration of Conformity
Marking with the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the
European Union (1999/5/EC).
This equipment meets the following conformance standards:
•
EN300 328 (2.4 Ghz), EN301 489-17, EN301 893 (5 Ghz), EN60950-1
•
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member states and
EFTA countries, except in France and Italy where restrictive use applies.
•
In Italy, the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to
use the device for setting up outdoor radio links and/or for supplying public access to telecommunications and/or
network services.
•
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may
be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information the end-user
should contact the national spectrum authority in France.
•
For complete DoC, visit the NETGEAR EU Declarations of Conformity website at:
•
For GNU General Public License (GPL) related information, please visit

Rate

3.5 / 5 based on 2 votes.

Popular NETGEAR Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top