Reference Manual for the Model Wireless ADSL Firewall Router DG834G
8-20
Virtual Private Networking (Advanced Feature)
202-10006-05, June 2005
•
The DG834G has a LAN IP address of 192.168.3.1.
•
The VPN client PC has a dynamically assigned address of 192.168.2.2.
While the connection is being established, the Connection Name field in this menu will say “SA”
before the name of the connection. When the connection is successful, the “SA” will change to the
yellow key symbol shown in the illustration above.
How to Set Up a Gateway-to-Gateway VPN Configuration
Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
Figure 8-20:
Gateway-to-Gateway VPN Tunnel
Set the LAN IPs on each DG834G to different subnets and configure each properly for the
Internet. The examples below assume the following settings:
Note:
While your PC is connected to a remote LAN through a VPN, you might not have
normal Internet access. If this is the case, you will need to close the VPN connection in
order to have normal Internet access.
Note:
This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
Table 8-2 on page 8-5
. If you have special requirements not
covered by these VPNC-recommended parameters, refer to
“How to Set Up VPN
Tunnels in Special Circumstances” on page 8-35
to set up the VPN tunnel.
A
B
VPN Tunnel
DG834G VPN
Firewall
DG834G VPN Firewall
PCs
PCs
192.168.0.1
192.168.3.1
14.15.16.17
22.23.24.25