Page 6 / 60
Scroll up to view Page 1 - 5
NB7 Series User Guide
YML901 Rev1
´
www.netcomm.com.au
Requirements
Your computer must meet the following minimum requirements.
•
Any operating system can be used
•
Internet Explorer 6.0 or Firefox 2.0
•
Ethernet network adapter
•
An active DSL Internet account
Package Contents
Package contents are listed below. For any missing items, please contact your dealer immediately. Product contents
vary for different models.
•
Router
•
Ethernet cable
•
Telephone cable
•
12V 1A DC Power Adapter
•
Easy Start Guide
Page 7 / 60
YML901 Rev1
NB7 Series User Guide
NB7 Series User Guide
www.netcomm.com.au
7
NB7 Series
Device Design – Front
Label
Action
Description
POWER
Off
No power is supplied to the device
Steady light
Connected to an AC power supply
ETHERNET 1-4
Off
No Ethernet connection
Steady light
Connected to an Ethernet port
Blinking light
Transmitting/Receiving data
Wireless
Off
Access point is disabled
Steady light
Access point is enabled
Blinking light
Transmitting/Receiving data
DSL
Off
No DSL signal
Blinking light
Establishing DSL signal
Steady light
DSL signal is established
INTERNET
Off
No Internet connection
Green light
Connected to the Internet
Green Blinking light
Transmitting/Receiving data
Red Blinking light
Cannot establish Internet connection
Page 8 / 60
NB7 Series User Guide
YML901 Rev1
µ
www.netcomm.com.au
Device Design – Back
Label
Description
DSL
Connecting the telephone cable
ETHERNET 1-4
Connecting with computers/devices through Ethernet cable
RESET
Resetting the device. Press for 10 seconds to reset.
POWER (12V 1A DC)
Connecting with the 12V 1A DC power adapter
ON/OFF
Switching the device on/off
Antenna
Sending/receiving wireless signals
Page 10 / 60
NB7 Series User Guide
YML901 Rev1
10
www.netcomm.com.au
Getting Started
Setting up the device is easy. The diagram below provides an outline of the steps needed to complete the
installation. Brief descriptions appear beside each step. Detailed instructions are provided in the subsequent pages.
Setup the Device
When installing the router, find an area where there are enough electrical outlets for the router, the main computer,
and your other computer devices.
To setup the router:
1.
Plug one end of the Ethernet cable from the router’s ETHERNET port and then plug the other end into the
Ethernet port in your computer.
2.
If you have another device you need to connect to the router, use another Ethernet cable. Plug one end
of the Ethernet cable from the computer’s Ethernet port and then plug the other end into an available
Ethernet port in the router.
3.
Plug one end of the telephone cable from the ADSL Filter’s ADSL port and then plug the other end into
the router’s DSL port. (see
Do I need a Microfilter
on
page 12
)
4.
Connect the power adapter from the router’s 12V 1A DC port into the electrical outlet.
5.
Push the power button into the on position.
19216811.live