Page 16 / 57
Scroll up to view Page 11 - 15
NB604N
–
ADSL2+ Wireless N300 Modem Router
16
NetComm NB604N
–
ADSL2+ Wireless N300 Modem
YML604X
www.netcommwireless.com
xTM
The Asynchronous Transfer Mode (ATM) page shows information about the currently configured ATM interface.
xDSL
The xDSL page shows information about the currently configured xDSL connection and connection conditions.
Page 17 / 57
www.netcommwireless.com
17
NetComm NB604N
–
ADSL2+ Wireless N300 Modem
YML604X
Route
The Route page lists the current routing table entries.
ARP
The Address Resolution Protocol (ARP)page shows the current ARP table entries.
DHCP
The DHCP page lists the current DHCP leases in use on the NB604N.
Page 18 / 57
NB604N
–
ADSL2+ Wireless N300 Modem Router
18
NetComm NB604N
–
ADSL2+ Wireless N300 Modem
YML604X
www.netcommwireless.com
Basic Setup
Quick Setup
The Quick Setup page is used to quickly and easily configure your Internet connection.
1.
Enter the username provided by your Internet Service Provider (ISP) in the PPP Username field.
2.
Enter the password provided by your ISP in the PPP Password field.
3.
Click Apply/Save.
4.
Click “Next” and view your connection information. The
NB604N will then automatically attempt to connect using the details
you entered.
Advanced Setup
The Advanced Setup page provides configuration options for other network and connection based functions of the NB604N. Please
see the following pages for an explanation of these functions.
Page 19 / 57
www.netcommwireless.com
19
NetComm NB604N
–
ADSL2+ Wireless N300 Modem
YML604X
Layer 2 Interface
The Layer 2 Interface pages allow you to add or remove ATM interfaces and configure the behaviour of the Ethernet ports.
ATM Interface
To remove a currently configured ATM Interface, Click the remove checkbox corresponding to the chosen interface and click
Remove.
To Add a new Interface, click the add button and enter the appropriate configuration information as shown below:
PARAMETER
DEFINITION
VPI/VCI
Enter the PVC identifier for your service. This will usually be 8/35 for users in Australia. For New Zealand users the VPI will
usually be 0 and the VCI will usually be 100.
DSL Latency
Select the DSL latency path you wish to use.
DSL Link Type
Select the type of connection
–
PPPoE (EoA), PPPoA or IPoA
Connection Mode
Select the type of connection.
Encapsulation Mode
Select the type of encapsulation utilised by your service. Options include LLC/SNAP-BRIDGING or VC/MUX.
QoS Settings
Select the appropriate Quality of Service settings to apply to this connection
Click Apply/Save to save the new Interface.
Page 20 / 57
NB604N
–
ADSL2+ Wireless N300 Modem Router
20
NetComm NB604N
–
ADSL2+ Wireless N300 Modem
YML604X
www.netcommwireless.com
ETH Interface
To remove a currently configured ATM Interface, Click the remove checkbox corresponding to the chosen interface and click
Remove.
To Add a new Interface, click the add button and select the appropriate configuration options as shown below:
PARAMETER
DEFINITION
ETH Port
Select the Ethernet port to apply the configuration to.
Connection Mode
Select the connection mode.
(VLAN MUX is typically used to access services such as IPTV)
Click Apply/Save to save the new Interface.
19216811.live