Page 51 / 52 Scroll up to view Page 46 - 50
51
User Guide
© 2015
Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
±
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
±
Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Hereby, Luxul, 14203 Minuteman Drive, Suite 201, Draper, Utah, 84020, declares that
this Luxul device is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
For a copy of this report send a self addressed stamped envelope to:
Luxul CE, 14203 Minuteman Drive, Suite 201, Draper, Utah, 84020.
Industry Canada (RSS-Gen Issue 2)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2)this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareilsradio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1)l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compli-
ance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la
conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information canadienne sur l’exposition
et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune autre antenne ou
émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20 cen-
timètres entre le radiateur et votre corps.
CAN ICES-03(B)/NMB-3(B)
Page 52 / 52
52
XWR-1750
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XWR-1750
Vers: 022515
APPENDIX 1: COMMON COMMANDS
Common Commands
Description
Cmd
Enter the command line mode of a Windows system (applicable to
Windows2000 and higher).
ipconfig
Displays the IP address of any network adapters on the computer. (i.e.
ipconfig /all)
Must be run from the command line.
Ping
Used to test for network connectivity and device/system recognition.
A device sends a packet to the target host and asks for a response. If
the device receives a response from the target host, it can then see
the network response time and connection status between the local
device and target host. (i.e. ping 192.168.0.1) Must be run from the
command line.
netstat
Displays details of active network connections including routing table
and network interface information. Can also be used to count the
active network connections. Must be run from the command line.
Tracert
Displays the path taken by a packet before reaching the target host
and the specific time when it reached each node. Similar to the Ping
command, but provides more detailed information. Displays the entire
path and IP address of each node in the path and total elapsed time.
Must be run from the command line.

Rate

3.5 / 5 based on 2 votes.

Popular Luxul Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top