Page 81 / 82 Scroll up to view Page 76 - 80
81
Figure 6: Authentication success
4.2
DUT authenticate PC2 using PEAP-TLS.
1. PC2 choose the SSID of DUT as the Access Point.
2. Set authentication type of wireless client and RADIUS server both to
PEAP_TLS.
3. Disable the wireless connection and enable again.
4.The DUT will send the user's certificate to the RADIUS server, and then
send the message of authentication result to PC2.
5. Windows XP will prompt that the authentication process is success or fail
and end the authentication procedure.
6. Terminate the test steps when PC2 get dynamic IP and PING remote host
successfully.
Support Type:
The router supports the types of
802.1x Authentication:
PEAP-CHAPv2 and PEAP-TLS.
Note.
1.PC1 is on Windows XP platform without Service Pack 1.
2.PC2 is on Windows XP platform with Service Pack 1a.
3.PEAP is supported on Windows XP with Service Pack 1 only.
4.Windows XP with Service Pack 1 allows 802.1x authentication only when data encryption
function is enable.
Page 82 / 82
82
A
A
A
p
p
p
p
p
p
e
e
e
n
n
n
d
d
d
i
i
i
x
x
x
C
C
C
R
R
R
e
e
e
s
s
s
e
e
e
t
t
t
t
t
t
o
o
o
f
f
f
a
a
a
c
c
c
t
t
t
o
o
o
r
r
r
y
y
y
d
d
d
e
e
e
f
f
f
a
a
a
u
u
u
l
l
l
t
t
t
Reset to factory Default
There are 2 methods to reset to default.
1.
Restore with RESET button
First, turn off the router and press the RESET button in. And then, power on the router and push the RESET button
down until the Status LED start flashing, then remove the finger. If LED flashes about 8 times, the RESTORE
process is completed. However, if LED flashes 2 times, repeat.
2.
Restore directly when the router power on
First, push the RESET button about 5 seconds , and STATUS will start flashing about 5 times), remove
the finger.
. The RESTORE process is completed.

Rate

4.5 / 5 based on 2 votes.

Popular LevelOne Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top