Legrand On-Q DA1004 Router Manual PDF (Setup & Configuration Guide)

Given below is full router user manual of Legrand On-Q DA1004 router model. You can also download this manual in PDF Format to read later on your computer.

Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.

Page 1 / 30
4 PORT ROUTER/SWITCH (P/N DA1004)
OWNER’S MANUAL
1307993 REV O
Page 2 / 30
ii
301 Fulling Mill Road, Suite G
©Copyright 2006 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA
17057
www.onqlegrand.com
(800)-321-2343
FCC Certifications
This equipment generates and uses radio frequency energy and if not installed and used properly, that is,
in strict accordance with the instructions provided with the equipment, may cause interference to radio
and TV communication. The equipment has been tested and found to comply with the limits for a Class A
computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are
designed to provide reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If you suspect this
equipment is causing interference, turn your Router/Switch on and off while your radio or TV is showing
interference, if the interference disappears when you turn your Router/Switch off and reappears when you
turn it back on, there is interference being caused by the Router/Switch.
You can try to correct the interference by one or more of the following measures:
±
Reorient the receiving radio or TV antenna where this may be done safely.
±
To the extent possible, relocate the radio, TV or other receiver away from the Router/Switch.
±
Plug the Router/Switch into a different power outlet so that the Router/Switch and the receiver are on
different branch circuits.
If necessary, you should consult the place of purchase or an experienced radio/television technician for
additional suggestions.
CE Mark Warning
This is a class A device, In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
All trademarks and brand names are the property of their respective proprietors.
Specifications are subject to change without prior notification.
Page 3 / 30
iii
301 Fulling Mill Road, Suite G
©Copyright 2006 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA
17057
www.onqlegrand.com
(800)-321-2343
TABLE OF CONTENTS
I.
Introduction
1
II.
Product Overview
2
A.
Features
2
B.
Components Included
2
C.
Detailed Physical Description
3
III.
Installation
4
A.
“Rough-In” Steps
4
B.
“Trim-Out” Steps
4
IV.
Initial Configuration
5
A.
Configuring a Network Interface Card to talk to the Router/Switch
5
B.
Logging on to the Router/Switch
6
C.
Using the Setup Wizard
7
1. Cable Modem Setup
8
2. DSL Modem Setup
9
3. DNS Configuration
9
D.
Contact Information
10
V.
Advanced Configuration
11
A.
System Operations
11
B.
WAN Configuration
14
C.
LAN Configuration
16
D.
NAT Configuration
17
E.
Firewall Configuration
20
F.
Routing Configuration
22
G.
UpnP Configuration
23
H.
DDNS Configuration
24
VI.
Logging Out
24
Glossary of Terms
25
Page 4 / 30
1
301 Fulling Mill Road, Suite G
©Copyright 2006 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA
17057
www.onqlegrand.com
(800)-321-2343
I. Introduction
The On-Q/Legrand 4 Port Router/Switch (P/N DA1004) is a flexible hardware configurable switch/router
product designed to be used as a router with an integrated 4-port Fast Ethernet switch, or just as a 4-
port Fast Ethernet switch for use with a 3
rd
party external router. It is the perfect solution to connect a
small group of PCs to a high-speed broadband Internet connection (see
Figure 1
). Up to 253 users can
have high-speed Internet access simultaneously via one single IP address (Internet account) of the
Cable/xDSL modem.
With its built in NAT technology, this product also serves as an Internet firewall, protecting your network
from being accessed by outside users. All incoming data packets are monitored and filtered. The
Router can also be configured with Client Filtering, to filter internal users’ access to the Internet.
The built-in 4-port Fast Ethernet Switch lets users plug the network cable into the device without buying
additional Hub/Switch.
Figure 1
DA1004
To Network
Page 5 / 30
2
301 Fulling Mill Road, Suite G
©Copyright 2006 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA
17057
www.onqlegrand.com
(800)-321-2343
II.
Product Overview
A. Features
Allows multiple users to share a single Internet line
Supports up to 253 users
Internet access via Cable or xDSL modem
Access private LAN servers from the public network
Equipped with four LAN ports (10/100M) and one WAN port (10/100M)
Supports DHCP (Server/Client) for easy setup
Supports advanced features such as: Special Applications, Port Mapping, DMZ, Virtual
Servers, ALG and Firewall options
Allows monitoring and logging router system status
Web-based GUI for configuration and management
Remote management over the Internet
Switch to disconnect router from 4-port switch
B. Components Included
The On-Q/Legrand 4 Port Router/Switch includes the following parts:
Router/Switch Module
Router/Switch DC Power Supply
Router/Switch User Guide

Rate

3.5 / 5 based on 2 votes.

Popular Legrand Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top